ZDI232ZPAK2ZPK Datasheet, PDF (1/10 Pages) Zilog, Inc. – Keyed 40-conductor ribbon cable

ZDI232ZPAK2ZPK
ZPAK II Debug Interface Module
UM016301-1003
User Manual
Introduction
This document describes how to setup and use the ZiLOG ZPAK II Debug Interface Mod-
ule with your ZiLOG development kit. The ZPAK II module enables a development PC
running ZDS II to communicate with a ZiLOG development kit. It also provides an Ether-
net interface to the development PC.
The kit includes:
• ZPAK II module
• DB9-to-ID10 serial cable
• Keyed 40-conductor ribbon cable
• Target Interface Module (TIM)
• User Manual
• CD-ROM with ZDS II software and additional documentation
Installing and Configuring ZPAK II
The ZPAK II module features an Ethernet interface and an RS-232 console port. Slight
modifications to your PC’s network configuration may be required for first-time use. Fol-
low the steps in this section to install and configure the ZPAK II module. See Figures 1
and 2.
Development PC
Ethernet
Hub
RJ-45
RJ-45
RS-232
5 VDC
ZPAK II
eZ80^¤
Development
De^Pv^le^al^to^fop^rm^ment
TIM ZDI
Ki_et_Z80^¤
Development
Module
9 VDC
Figure 1. Hardware Setup using an Ethernet Hub
ZiLOG Worldwide Headquarters • 532 Race Street • San Jose, CA 95126
Telephone: [phone] • Fax: [phone] • www.zilog.com