Z86L33 Datasheet, PDF (1/16 Pages) Zilog, Inc. – CMOS Z8 CONSUMER CONTROLLER PROCESSOR

Z86L33/L43
CP96LVO1501
PRELIMINAR Y
CUSTOMER P ROCUREMENT S PECIFICA TION
FEATURES
ROM
Part
(KB)
Z86L33
4
Z86L43
4
* General-Purpose
RAM*
(Bytes)
237
236
Speed
(MHz)
8
8
s 40-Pin DIP, 44-Pin PLCC and QFP Packages (L43)
28-Pin DIP, 28-Pin SOIC (L33)
s 2.0- to 3.9-Volt Operating Range
s Low-Power Consumption
s 0°C to +70°C Operating Range
s Expanded Register File (ERF)
Z86L33/L43
CMOS Z8^®
CONSUMER CONTROLLER PROCESSOR
s 32 Input/Output Lines (L43)
24 Input/Output Lines (L33)
s Vectored, Prioritized Interrupts with
Programmable Polarity
s Two Analog Comparators
s Two Programmable 8-Bit Counter/Timers,
Each with Two 6-Bit Programmable Prescaler
s Watch-Dog Timer (WDT)/Power-On Reset (POR)
s On-Chip Oscillator that Accepts a Crystal, Ceramic
Resonator, LC, RC, or External Clock
s RAM and ROM Protect
GENERAL DESCRIPTION
The Z86L33/L43 Consumer Controller Processor (CCP^™)
is a member of Zilog's Z8^® single-chip microcontroller
family with enhanced wake-up circuitry, programmable
Watch-Dog Timers (WDT), and low-noise/EMI options.
These enhancements result in a more efficient, cost-
effective design and provide the user with increased
design flexibility over the standard Z8 microcontroller
core. This low-power consumption CMOS microcontroller
offers fast execution, efficient use of memory, sophisti-
cated interrupts, input/output bit manipulation capabili-
ties, and easy hardware/software system expansion.
The Z86L33/L43 features an Expanded Register File (ERF)
to allow access to register-mapped peripheral and I/O
circuits. Four basic address spaces are available to sup-
port this wide range of configurations: Program Memory,
Register File, External Data Memory (L43), and ERF. The
Register File is composed of 236 bytes of general-purpose
registers, four I/O port registers, and 15 control and status
registers. The ERF consists of three control registers
(Banks 0,D, and F)
For applications demanding powerful I/O capabilities, the
Z86L33 provides 24 pins, and the Z86L43 provides 32 pins
dedicated to input and output. These lines are configurable
under software control to provide timing,
status signals, parallel I/O with or without handshake, and
address/data bus for interfacing external memory.
To unburden the system from coping with real-time tasks
such as counting/timing and data communication, the
Z86L33/L43 offers two on-chip counter/timers with a large
number of user-selectable modes.
With ROM/ROMless selectivity, the Z86L43 provides both
external memory and pre-programmed ROM, which
enables this Z8 microcontroller to be used in high-volume
applications, or where code flexibility is required.
Notes:
All Signals with a preceding front slash, "/", are active Low, e.g.:
B//W (WORD is active Low); /B/W (BYTE is active Low, only).
Power connections follow conventional descriptions below:
Connection
Power
Ground
Circuit
V_CC
GND
Device
V_DD
V_SS
CP96LVO1501 (6/96)
1