|
ZXCD100MOEVAL Datasheet, PDF (1/8 Pages) Zetex Semiconductors – 100W CLASS D AUDIO AMPLIFIER EVALUATION BOARD | |||
|
ZXCD100MOEVAL
100W CLASS D AUDIO AMPLIFIER EVALUATION BOARD
DESCRIPTION
The ZXCD100MOEVAL evaluation board is based on
the ZXCD1000 Class D audio amplifier solution from
Zetex. This board allows the user to evaluate the high
fidelity audio performance offered by the Zetex
solution, with an output power upto 100W into 4â.
FEATURES
⢠Class D architecture
⢠Single power supply
⢠Output power ( Vsupply = 35V)
INTRODUCTION
The ZXCD100MOEVAL is a 100W RMS (4â Load) high
performance class D amplifier. The circuitry contains
MOSFET devices and should therefore be handled
appropriately.
The board requires a single rail power supply of 13
volts minimum and 35 volts maximum. Voltages in
excess of 35 volts may cause permanent damage to the
board.
100 W into 4â
⢠THD + N <0.8% @ 90% power
⢠>90% efficiency
⢠Flat frequency response 20Hz â 20 kHz
⢠Turn on / turn off pop suppression
⢠Over current protection
The heart of the solution is the ZXCD1000 class D
controller IC and the user should refer to the ZXCD1000
data sheet for further technical information.
The circuit features pop suppression and over current
protection.
⢠Noise floor â115dB
Note: The ZXCD100MOEVAL is intended as an
evaluation platform for Zetex Class D solutions. Zetex
accepts no liability for external equipment connected
to the ZXCD100MOEVAL or any other form of
consequential damage or loss.
ISSUE 2 - JULY 2002
1
|
▷ |