CRO3064A Datasheet, PDF (2/2 Pages) Z-Communications, Inc – LOW COST - HIGH PERFORMANCE VOLTAGE CONTROLLED OSCILLATOR

LOW COST - HIGH PERFORMANCE
VOLTAGE CONTROLLED OSCILLATOR
TUNING CURVE, typ.
3100
3095
3090
3085
3080
3075
3070
3065
3060
3055
3050
3045
3040
3035
3030
3025
0
0.5
1
1.5
2
2.5
3
3.5
TUNING VOLTAGE (Vdc)
POWER CURVE, typ.
6
CRO3064A
PAGE 2
85 °c
25 ^°c
-40 °c
4
4.5
5
4
25 ^°c
3
2
3044
3049
3054
3058
3063
3067
3072
3076
3081
3086
MINI-16
415-0061 REV. D
(DRAWING NOT TO SCALE)
0.500
0.475
0.405
0.305
0.205
0.105
0.025
0.000
P2
P1=VT
P2=RF OUT P3
P3=Vcc
BOTTOM VIEW
P1
GROUND PLANE SOLDER PLATED
FREQUENCY (MHz)
PHYSICAL DIMENSIONS
TYPICAL OF ALL PADS
SEE NOTE 3
0.415
0.315
DETAIL A
0.215
0.115
SEE DETAIL 'A'
.070
.037
TABS RANGE:
SEE NOTE 5.
(4 PLACES)
.031
.026
.052
.114
.220
.034
0.000
.150
TYP
NOTES:
1. THE INSIDE RADIUS OF ALL 16 HALF HOLES
AT THE PERIMETER OF THE BOARD ARE
PLATED TO PROVIDE A SURFACE FOR THE
ATTACHMENT OF THE VCO TO A PCB,
IN 13 LOCATIONS, WITH 3 PADS BEING
USED FOR ELECTROMECHANICAL INTERFACE.
16 SOLDER LOCATIONS REQUIRED.
2. THE SURFACE OF THE SHIELD IS TIN PLATED
AND MAY BE SOLDERED TO. THE SHIELD'S
BASE METAL IS COLD ROLLED STEEL.
3. THE GROUND PLANE IS GROUND AND ATTACHES
TO A GROUND TRACK ON THE UPPER SIDE OF
THE BOARD AS WELL AS THE SHIELD BY PTH.
4. UNLESS OTHERWISE NOTED ALL DIMENSIONS
ARE IN INCHES.
5. UNLESS OTHERWISE NOTED ALL TOLERANCES
ARE AS FOLLOWS:
TOLERANCES
.XXX= ± .010
.070 TYP
© Z-Communications, Inc.
Page 2
Printed in the U.S.A.