CLV1560A Datasheet, PDF (2/2 Pages) Z-Communications, Inc – VOLTAGE CONTROLLED OSCILLATOR

LOW COST - HIGH PERFORMANCE
VOLTAGE CONTROLLED OSCILLATOR
TUNING CURVE, typ.
1700
1675
1650
1625
1600
1575
1550
1525
1500
1475
1450
1425
1400
0
0.5
1
1.5
2
2.5
3
3.5
TUNING VOLTAGE (Vdc)
POWER CURVE, typ.
7
CLV1560A
PAGE 2
85 °c
25 ^°c
-40 °c
4
4.5
6
5
4
25 ^°c
3
2
1461
1479
1499
1521
1546
1574
1603
1630
1655
1676
MINI-14S-L
415-0063 REV. D
(DRAWING NOT TO SCALE)
0.500
0.475
0.415
0.315
0.215
0.090
0.025
0.000
P2
P1=VT
P2=RF OUT _P3
P3=Vcc
BOTTOM VIEW
P1
FREQUENCY (MHz)
PHYSICAL DIMENSIONS
TYPICAL OF ALL PADS
SEE NOTE 3
0.415
0.315
DETAIL A
0.215
0.090 SEE DETAIL 'A'
.065
.030
TABS RANGE:
SEE NOTE 5.
(4 PLACES)
.130
.034
0.000
.150
TYP
.031
.026
.052
.114
NOTES:
1. THE INSIDE RADIUS OF ALL 14 HALF HOLES
AT THE PERIMETER OF THE BOARD ARE
PLATED TO PROVIDE A SURFACE FOR THE
ATTACHMENT OF THE VCO TO A PCB
IN 11 LOCATIONS, WITH 3 PADS BEING
USED FOR ELECTROMECHANICAL INTERFACE.
14 SOLDER LOCATIONS REQUIRED.
2. THE SURFACE OF THE SHIELD IS TIN PLATED
AND MAY BE SOLDERED TO. THE SHIELD'S
BASE METAL IS COLD ROLLED STEEL.
3. THE GROUND PLANE IS GROUND AND ATTACHES
TO A GROUND TRACK ON THE UPPER SIDE OF
THE BOARD AS WELL AS THE SHIELD BY PTH.
4. UNLESS OTHERWISE NOTED ALL DIMENSIONS
ARE IN INCHES.
5. UNLESS OTHERWISE NOTED ALL TOLERANCES
ARE AS FOLLOWS:
TOLERANCES
.XXX= ± .010
.070 TYP
GROUND PLANE SOLDER PLATED
© Z-Communications, Inc.
Page 2
Printed in the U.S.A.