CLV0945A Datasheet, PDF (2/2 Pages) Z-Communications, Inc – LOW COST - HIGH PERFORMANCE VOLTAGE CONTROLLED OSCILLATOR

LOW COST - HIGH PERFORMANCE
VOLTAGE CONTROLLED OSCILLATOR
PAGE 2
TUNING CURVE, typ.
1020
1000
980
960
940
85 °c
920
25 ^°c
900
-40 °c
880
860
840
0
0.5
1
1.5
2
2.5
3
3.5
4
4.5
TUNING VOLTAGE (Vdc)
POWER CURVE, typ.
7
6
5
4
3
25 ^°c
2
1
0
854
873
889
905
921
937
954
971
985
998
MINI-14S
415-0060 REV. D
(DRAWING NOT TO SCALE)
0.500
0.475
0.415
0.315
0.215
0.090
0.025
0.000
P2
P1=VT
P2=RF OUT _P3
P3=Vcc
BOTTOM VIEW
P1
FREQUENCY (MHz)
PHYSICAL DIMENSIONS
TYPICAL OF ALL PADS
SEE NOTE 3
0.415
0.315
DETAIL A
0.215
0.090 SEE DETAIL 'A'
.065
.030
TABS RANGE:
SEE NOTE 5.
(4 PLACES)
.220
.034
0.000
.150
TYP
.031
.026
.052
.114
NOTES:
1. THE INSIDE RADIUS OF ALL 14 HALF HOLES
AT THE PERIMETER OF THE BOARD ARE
PLATED TO PROVIDE A SURFACE FOR THE
ATTACHMENT OF THE VCO TO A PCB
IN 11 LOCATIONS, WITH 3 PADS BEING
USED FOR ELECTROMECHANICAL INTERFACE.
14 SOLDER LOCATIONS REQUIRED.
2. THE SURFACE OF THE SHIELD IS TIN PLATED
AND MAY BE SOLDERED TO. THE SHIELD'S
BASE METAL IS COLD ROLLED STEEL.
3. THE GROUND PLANE IS GROUND AND ATTACHES
TO A GROUND TRACK ON THE UPPER SIDE OF
THE BOARD AS WELL AS THE SHIELD BY PTH.
4. UNLESS OTHERWISE NOTED ALL DIMENSIONS
ARE IN INCHES.
5. UNLESS OTHERWISE NOTED ALL TOLERANCES
ARE AS FOLLOWS:
TOLERANCES
.XXX= ± .010
.070 TYP
GROUND PLANE SOLDER PLATED
© Z-Communications, Inc.
Page 2
Printed in the U.S.A.