GBU401-GBU Datasheet, PDF (1/2 Pages) DONGGUAN YOU FENG WEI ELECTRONICS CO., LTD – GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER

GBU4005 THRU GBU410
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
REVERSE VOLTAGE:
50 to 1000 VOLTS
FORWARD CURRENT:
4.0 AMPERE
FEATURES
· Glass passivated chip junction
· Reliable low cost construction utilizing molded
plastic technique
· Ideal for printed circuit board
· Low forward voltage drop
· Low reverse leakage current
· High surge current capability
MECHANICAL DATA
Case: Molded plastic, GBU
Epoxy: UL 94V-O rate flame retardant
Terminals: Leads solderable per MIL-STD-202,
method 208 guaranteed
Mounting position: Any
Weight: 0.15ounce, 4.0gram
GBU
3.2X45°
7°
7°
R7,6
7°
7°
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics
Ratings at 25 ambient temperature unless otherwise specified.
Single phase, half wave, 60H_Z, resistive or inductive load.
For capacitive load, derate current by 20%.
Maximum Recurrent Peak Reverse Voltage
Maximum RMS Voltage
Maximum DC Blocking Voltage
Maximum Average Forward
T_C=100 (Note 1)
Rectified Current at
T_A= 40 (Note 2)
Peak Forward Surge Current,
8.3ms single half-sine-wave
superimposed on rated load (JEDEC method)
Maximum Forward Voltage
at 4.0A DC and 25
Maximum Reverse Current
at T_A=25
at Rated DC Blocking Voltage
T _A=125
Typical Junction Capacitance (Note 3)
Typical Thermal Resistance (Note 2)
Typical Thermal Resistance (Note 1)
Operating and Storage Temperature Range
Symbols GBU4005 GBU401 GBU402 GBU404 GBU406 GBU408 GBU410
V_RRM
50
100
200
400
600
800 1000
V_RMS
35
70
140
280
420
560
700
V_DC
50
100
200
400
600
800 1000
4.0
I_(AV)
3.0
Units
Volts
Volts
Volts
Amp
I_FSM
150
Amp
V_F
I_R
C_J
R_θJA
R_θJC
T_J Tstg
1.0
5.0
500
100
45
22
4.2
-55 to +150
Volts
uAmp
pF
/W
/W
NOTES: 1- Unit case mounted on 1.6 x 1.6 x 0.06” thick (4.0 x4.0 x 0.15cm) Al. Plate
2- Units mounted on P.C.B. with 0.5 x 0.5" (12 x 12mm) copper pads and 0.375" (9.5mm) lead length
3- Measured at 1 MH_Z and applied reverse voltage of 4.0 VDC.
4- Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screw
www.yfwdiode.com