RS2A Datasheet, PDF (1/2 Pages) Shanghai Sunrise Electronics – SURFACE MOUNT FAST SWITCHING RECTIFIER

DATA SHEET
SEMICONDUCTOR
RS2 A THRU RS2 M
RECTIFIER SPECIALISTS
TECHNICAL SPECIFICATIONS OF SURFACE MOUNT FAST RECOVERY
RECTIFIER
VOLTAGE RANGE - 50 to 1000 Volts CURRENT - 2 .0 Ampere
FEATURES
ldeal for surface mounted applications
Low leakage current
Glass passivated junction
High temperature soldering : 260°C /10 seconds at terminals
Pb free product at available : 99% Sn above meet RoHS environment
substance directive request.
MECHANICAL DATA
Case: Molded plastic
Epoxy: UL 94V-0 rate flame retardant
Terminals: Solder plated, solderable per
MIL-STD-750, Method 2026
Polarity: As marked
Mounting position: Any
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 C ambient temperature unless otherwise specified.
Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
SMA/DO-214AC Unit:inch(mm)
.062(1.60)
.047(1.20)
.114(2.90)
.098(2.50)
.181(4.60)
.157(4.00)
.096(2.44)
.078(2.00)
.060(1.52)
.030(0.76)
.008(.203 )
.002(.051)
.208(5.28)
.188(4.80)
.012(.305)
.006(.152)
SYMBOL ^{RS2A RS2B RS2D RS2G RS2J RS2K RS2M} UNITS
MARKING CODE
RS2A RS2B RS2D RS2G RS2J RS2K RS2M
Maximum Recurrent Peak Reverse Voltage
VRRM
50
100
200
400
600
Maximum RMS Voltage
VRMS
35
70
140
280
420
Maximum DC Blocking Voltage
VDC
50
100
200
400
600
Maximum Average Forward Rectified Current at TA = 55 C
IO
2.0
Peak Forward Surge Current 8.3 ms single half sine-wave
IFSM
30
superimposed on rated load (JEDEC Method)
Maximum Forward Voltage at 2.0A DC
VF
1.30
Maximum DC Reverse Current at
@TA = 25 C
5.0
IR
Rated DC Blocking Voltage
@TA = 125 C
150
Maximum Reverse Recovery Time (Note 3)
trr
150
250
Maximum Thermal Resistance (Note 2)
R JL
30
Typical Junction Capacitance (Note 1)
CJ
15
Operating and Storage Temperature Range
TJ, TSTG
-55 to +150
NOTES :1. Measured at 1.0 MHz and applied reverse voltage of 4.0VDC
2. Thermal Resistance (Junction to Ambient), .24in (6.0mm ) 2 copper pads to each terminal.
3. Test Conditions: IF = 0.5A, IR = 1.0A, IRR = 0.25A
800 1000 Volts
560
700 Volts
800 1000 Volts
Amps
Amps
Volts
uAmps
500
nSec
C/W
pF
C
http://www.yeashin.com
1
REV.02 20150105