P4SMAJ5.0 Datasheet, PDF (1/5 Pages) Diotec Semiconductor – Surface mount unidirectional and bidirectional Transient Voltage Suppressor Diodes

SEMICONDUCTOR
DATA SHEET
P4SMAJ Series
SURFACE MOUNT TRANSIENT VOLTAGE SUPPRESSOR
VOLTAGE - 5.0 to 440 Volts 400 Watt Peak Power Pulse
SMA/DO-214AC Unit:inch(mm)
FEATURES
ΘFor surface mounted applications in order to optimize board space.
ΘLow profile package
ΘBuilt-in strain relief
ΘGlass passivated junction
ΘExcellent clamping capability
ΘLow inductance
ΘFast response time: typically less than 1.0 ps from 0 volts to BV min
ΘTypical IR less than 1µA above 10V
ΘHigh temperature soldering : 250°C/10 seconds at terminals.
ΘPlastic package has Underwriters Laboratory Flammability
Classification 94V-O
ΘHigh temperature soldering : 260^OC / 10 seconds at terminals
ΘPb free product at available : 99% Sn above meet RoHS
environment substance directive request
MECHANICAL DATA
ΘCase: JEDEC DO-214AC low profile molded plastic
ΘTerminals: Solder leads, solderable per MIL-STD-750, Method 2026
ΘPolarity: Indicated by cathode band except Bi-directional types.
ΘStandard Packageing: 12mm tape per(EIA-481)
ΘWeight: 0.002 ounces, 0.064 gram
.062(1.60)
.047(1.20)
.114(2.90)
.098(2.50)
.181(4.60)
.157(4.00)
.096(2.44)
.078(2.00)
.060(1.52)
.030(0.76)
.008(.203 )
.002(.051)
.208(5.28)
.188(4.80)
.012(.305)
.006(.152)
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25°Cambient temperature unless otherwise specified. Resistive or inductive load, 60Hz.
For Capacitive load derate current by 20%.
RATING
SYMBOL
Peak Power Dissipation at TA=25°C, TP=1ms(Note 1,2,5)Fig.1
PPPM
Peak Forward Surge Current, per Figure 5(Note 3)
IFSM
Peak Pulse Current Current on 10/1000µs waveform(Note
1,2,5)Fig.2
IPPM
Steady State Power Dissipation(Note 4)
PM(AV)
Operating and Storage Temperature Range
TJ, TSTG
NOTES:
1.Non-repetitive current pulse, per Fig. 3 and derated above TA=25°Cper Fig. 2.
2.Mounted on 5.0mm2 Copper pads to each terminal.
3.8.3ms single half sine-wave, duty cycle= 4 pulses per minutes maximum.
4.lead temperature at 75°C=TL.
5.Peak pluse power waveformis 10/1000µS.
VALUE
Minimum 400
40.0
See Table 1
1.0
-55 to +150
UNITS
Watts
Amps
Amps
Watts
°C
http://www.yeashin.com
1
REV.03 20130403