GBPC6005 Datasheet, PDF (1/2 Pages) Shanghai Lunsure Electronic Tech – SINGLE PHASE GLASS PASSIVATED BRIDGE RECTIFIER

DATA SHEET
SEMICONDUCTOR
GBPC6005 THRU GBPC610
GLASS PASSIVATED SINGLE-PHASE BRIDGE RECTIFIER
Reverse Voltage - 50 to 1000 Volts Current Voltage - 6 .0 Amperes
FEATURES
Plastic package has underwriters laboratory
Flammability classification 90V - 0
Glass passivated chip junction
High case dielectric with standing voltage of 1500VRMS
Typical IR less than 0.5 A
High surge current capability
Ideal for printed circult boards
High temperature soldering guaranteed:
260/10seconds, 0.375" (9.5mm) lead length at 5 lbs (2.3kg) tension.
High temperature soldering : 260^OC / 10 seconds at terminals
Pb free product at available : 99% Sn above meet RoHS
environment substance directive request
GBPC6/ 8 Unit:inch(mm)
MECHANICAL DATA
Case: Molded plastic body over passivated junctions
Terminals: Plated leads solderable per MIL - STD - 750 method 2026
Mounting position: Any (Note 1)
Weight: 0.1 ounce, 2.8gram
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Ratings at 25 ambient temperature unless otherwise specified
GBPC GBPC GBPC GBPC GBPC GBPC GBPC
SYMBOLS
UNIT
6005 601 602 604 606 608 610
Maximum Repetitive Peak Reverse Voltage
VRRM 50 100 200 400 600 800 1000 Volts
Maximum RMS Voltage
VRMS
35
70 140 280 420 560 700 Volts
Maximum DC Blocking Voltage
VDC
50 100 200 400 600 800 1000 Volts
Maximum Average Forward
output current at
TC = 500 (Note 2)
TA = 40 (Note 3)
I(AV)
6.0
Amps
3.0
Peak Forward Surge Current
single half sine - wave superimposed on
IFSM
175
Amps
rated load (JEDEC method )
Maximum Instantaneous Forward Voltage Drop per
VF
element per leg 3.0A
1.0
Volts
Rating for Fusing (t < 8.3ms)
I2t
1.0
A2s
Maximum DC Reverse Current at rated TA = 25
IR
DC blocking voltage per leg
TA = 125
5.0
uA
500
Typical Junction Capacitance per leg at 4.0V, 1MHz
Cj
186
90
pF
Typical Thermal Resistance
per leg (Note 1)
RJI
7.3
/W
RJA
22
Operating and Storage Temperature Range
TJ, TSTG
-55 to +150
NOTES:
1. Bolt down on heatsink with silicon thermal compound between bridge and mounting surface for maximum heat transfer with
#6 screw.
2.Unit mounted on 4.0" * 4.0" * 0.11" think ( 10.5*10.5*0.3cm) Al. Plate.
3. Unit mounted on P.C.B. at 0.375" (9.5mm) lead with 0.5" * 0.5" (12*12mm) copper pads
http://www.yeashin.com
1
REV.02 20120305