|
YDA137 Datasheet, PDF (1/20 Pages) YAMAHA CORPORATION – D- 2 STEREO 5W DIGITAL AUDIO POWER AMPLIFIER | |||
|
YDA137
D- 2
STEREO 5W DIGITAL AUDIO POWER AMPLIFIER
â Overview
YDA137 (D-2) is a high efficient digital audio power amplifier IC that operates on a single 5V power supply.
With YDA137 in BTL connection, an audio power amplifier with a maximum output of 5W (RL=2Ω)Ã2ch can be
configured with one chip.
YDA137 converts an input analog data into a digital pulse by the digital modulation circuit in the IC and outputs a high
current digital pulse from the output buffer circuit. This digital pulse signal is converted into an audio signal by an
external low-pass filter and is output to the speaker.
Low-distortion rate characteristics and high S/N ratio are realized as a digital amplifier among same class, by adopting
Yamahaâs unique modulation system.
In addition, class AB headphone amplifier with output of 20mW (RL=16Ω)Ã2ch is embedded and switching between
digital amplifier output and headphone amplifier output can be done by the control of terminal termination.
YDA137 has the over-current protection function for speaker terminals, the high-temperature protection function for IC,
and the pop noise rejection function.
IC operation can be restricted by the two control signals of /SLEEP and /MUTE. /SLEEP signal can stop all functions and
decrease the consumption power to a minimum. In addition, /MUTE signal can pull-down the output buffer (hereinafter,
described as WL) and make the output mute.
â Features
ã»High Output Power
5.0 W ï¼ VDD=5.0V, RL=2Ω, THD+N<10%
3.7 W ï¼ VDD=5.0V, RL=3Ω, THD+N<10%
3.0 W ï¼ VDD=5.0V, RL=4Ω, THD+N<10%
ã»High Efficient Operation
75 % ï¼ VDD=5.0V, RL=2Ω, Po=5W
80 % ï¼ VDD=5.0V, RL=3Ω, Po=3W
ã»Low Distortion Rate (THD+N)
0.03 % ï¼ 1kHz, RL=2Ω, Po=2.5W
0.02 % ï¼ 1kHz, RL=3Ω, Po=1.5W
ã»High S/N Ratio
105dB ï¼ VDD=5.0V, input sensitivity 1.0Vrms,
RL=2Ω, Po=5W
98dB ï¼ VDD=5.0V, input sensitivity 150mVrms,
RL=2Ω, Po=5W
ã»IC Low Consumption Current
25 mA ï¼ VDD=5.0V, no signal (no filter)
10 mA ï¼ VDD=5.0V, at mute
1 µA ï¼ VDD=5.0V, at sleep
ã»CS(Channel Separation)
80dB ï¼ 1kHz
ã»Class AB headphone amp. is embedded.
20mW ï¼ VDD=5.0V, RL=16Ω, THD+N<1.0%
ã»Arbitral gain setting with external resistor is possible.
ã»Sleep function by /SLEEP terminal
ã»Output mute function by /MUTE terminal
ã»Output Over-Current Protection Function
(Ground short-circuit/Load short-circuit)
ã»Over-Temperature Protection Function
ã»Auto Resume Function from Over-Current,
High-Temperature Protection.
ã»Monaural Function by /MONO terminal
ã»Pop Noise Rejection Function at power-up or
power-cutoff.
ã»Analog input / BTL(Bridge-Tied Load) output
ã»28pin plastic TSSOP
pin lead plating with Pd-free (YDA137-AZ)
YDA137 CATALOG
CATALOG No.:LSI-4DA137A30
2005.1
|
▷ |