RC0201FR-0722KL Datasheet, PDF (6/9 Pages) YAGEO Corporation – GENERAL PURPOSE CHIP RESISTORS

Chip Resistor Surface Mount ^{RC SERIES 0201}
Product specification 6
9
TESTS AND REQUIREMENTS
Table 4 Test condition, procedure and requirements
TEST
TEST METHOD
PROCEDURE
Temperature
Coefficient of
Resistance
(T.C.R.)
IEC 60115-1 4.8
At +25/–55 °C and +25/+125 °C
Formula:
T.C.R= -------R---²--–---R--¹-------- ×10⁶ (ppm/°C)
R₁(t₂–t₁)
Where
t₁=+25 °C or specified room temperature
t₂=–55 °C or +125 °C test temperature
R₁=resistance at reference temperature in ohms
R₂=resistance at test temperature in ohms
REQUIREMENTS
Refer to table 2
Life/Endurance IEC 60115-1 4.25.1
At 70±5 °C for 1,000 hours, RCWV applied for
1.5 hours on, 0.5 hour off, still air required
±(1.0%+0.05 Ω)
for 1%, 0.5% tol.
±(3.0%+0.05 Ω
for 5% tol.
<100 mΩ for Jumper
High
Temperature
Exposure/
Endurance at
Upper Category
Temperature
IEC 60068-2-2
1,000 hours at 125±5 °C, unpowered
±(1.0%+0.05 Ω)
for 1%, 0.5% tol.
±(2.0%+0.05 Ω)
for 5% tol.
<50 mΩ for Jumper
Moisture
Resistance
MIL-STD-202G Method-106G
Each temperature / humidity cycle is defined at 8
hours, 3 cycles / 24 hours for 10d. with 25 °C /
65 °C 95% R.H, without steps 7a & 7b,
unpowered
Parts mounted on test-boards, without
condensation on parts
Measurement at 24±2 hours after test conclusion
±(0.5%+0.05 Ω)
for 1%, 0.5% tol.
±(2.0%+0.05 Ω)
for 5% tol.
<100 mΩ for Jumper
Thermal Shock
MIL-STD-202G Method-107G
-55/+125 °C
Number of cycles required is 300. Devices
unmounted
Maximum transfer time is 20 seconds.
Dwell time is 15 minutes. Air – Air
±(0.5%+0.05 Ω)
for 1%, 0.5% tol.
±(1%+0.05 Ω)
for 5% tol.
<50 mΩ for Jumper
May 02, 2011 V.8
www.yageo.com