VCP24US05 Datasheet, PDF (1/2 Pages) XP Power Limited – Low Cost, Output Voltages from 5 to 24 V, PCB Mount

24 Watts
VCP Series
xppower.com
BRAND
• Low Cost
• Output Voltages from 5 to 24 V
• PCB Mount
• Open Frame & Encapsulated Versions
• IT & Medical Approvals
• Class II Construction
• No Load Input Power <0.3 W
Specification
Input
Input Voltage
Input Frequency
Input Current
Inrush Current
Power Factor
No Load Input Power
Input Protection
• 90-264 VAC
• 47-63 Hz
• 0.6 A max at 90 VAC
• 40 A max at 240 VAC, cold start at 25 °C
• EN61000-3-2, class A
• <0.3 W
• Internal T2.0A/250 V fuse in line
Output
Output Voltage
• See table
Initial Set Accuracy • ±2% at 50% load
Minimum Load
• No minimum load required
Start Up Delay
• 2 s max
Start Up Rise Time
• 50 ms typical
Hold Up Time
• 5 ms typical at full load and 115 VAC
Line Regulation
• ±0.5% max
Load Regulation
• 2% max, 0-100% load
Transient Response
• 10% max. deviation, recovery to <1%
within 500 µs for a 50% step load change
at 0.2 A/µs
Ripple & Noise
• See table
Overvoltage Protection • See table
Overload Protection • 120-280 %, auto recovery
Short Circuit Protection • Trip and restart (hiccup mode)
Temperature
Coefficient
• 0.2 %/°C
General
Efficiency
Isolation
Switching Frequency
MTBF
• See table
• 4000 VAC Input to Output
• 65 kHz typical
• 250 kHrs to MIL-HDBK-217F at 25 °C, GB
Environmental
Operating Temperature • 0 °C to +70 °C, derate from 100% load at
50 °C to 50% load at 70 °C
Cooling
• Natural convection
Operating Humidity • 5-90% RH, non-condensing
Storage Temperature • -20 °C to +80 °C
Vibration
• 10-300 Hz, 2 g 15 mins/sweep. 30 mins
for each of 3 axes
EMC & Safety
Emissions
Harmonic Currents
Voltage Flicker
ESD Immunity
Radiated Immunity
EFT/Burst
Surge
Conducted Immunity
Magnetic Field
Dips & Interruptions
Safety Approvals
• EN55011/22, level B conducted & radiated
• EN61000-3-2, class A
• EN61000-3-3
• EN61000-4-2, ±4kV indirect contact,
±8kV air, Perf Criteria A
• EN61000-4-3, 3 V/m, Perf Criteria A
• EN61000-4-4, level 2, Perf Criteria A
• EN61000-4-5, installation class 3,
Perf Criteria A
• EN61000-4-6, 3 V, Perf Criteria A
• EN61000-4-8, 1 A/m, Perf Criteria A
• EN61000-4-11, 30% 10 ms, 60% 100 ms,
100% 5000 ms, Perf Criteria A, B, B
• EN60950-1, cUL60950-1, IEC60950-1,
EN60601-1, cUL60601-1, IEC60601-1