POE Datasheet, PDF (1/2 Pages) XP Power Limited – Power Over Ethernet Compatible

100 Watts
POE Series
xppower.com
• Compact 2” x 4” x 1.2” Size
• Power Over Ethernet Compatible
• High Power Density 10.4 W/in³
• Level B Conducted Emissions
• EN61000 3 2, 3 Compliant
• Fits 1U Applications
• Convection cooled & Fan cooled Ratings
Specification
Input
Input Voltage
Input Frequency
Input Current
Inrush Current
Earth Leakage Current
Input Protection
• 90-264 VAC (120-370 VDC)
• 47-63 Hz; 440 Hz
• 1.8 A max at 115 VAC
1.1 A max at 230 VAC
• 40 A max at 230 VAC
• <1 mA at 264 VAC/60 Hz
• Internal 3.15 A fuse in line and neutral
Output
Output Voltage
• See table
Output Voltage Trim • ±5%
Initial Set Accuracy • ±1.0%
Minimum Load
• No minimum load required
Start Up Delay
• 2 s max
Start Up Rise Time
• 50 ms
Hold Up Time
• 16/75 ms min at 115/230 VAC
Line Regulation
• ±0.5%
Load Regulation
• ±1%
Over/Undershoot
• None at turn on/off
Transient Response
• 4% max. deviation, recovery to
within 1% in 500 µs for a 50-75-50%
load change
Ripple & Noise
• 1% pk-pk, 20 MHz bandwidth
Overvoltage Protection • 115-135% Vnom, recycle input to reset
Overload Protection
• 110-150% on primary power limit,
auto recovery
Short Circuit Protection • Trip and restart (Hiccup mode)
Temperature
Coefficient
• 0.05%/°C
General
Efficiency
Isolation
Switching Frequency
Power Density
MTBF
• Typically 85%
• 4000 VAC Input to Output
1500 VAC Input to Ground
1500 VAC Output to Ground
• 55 kHz typical
• 10.4 W/In³
• 250 kHrs per MIL-HDBK-217F
Environmental
Operating Temperature • 0 °C to +70 °C. Refer to derating curves
for specific operating limitations.
Cooling
• Convection & fan-cooled ratings
(see derating curves)
Operating Humidity • 95% RH, non-condensing
Storage Temperature • -40 °C to +85 °C
Operating Altitude
• 3000 m
Shock
• 30 g pk, half sine, 6 axes
Vibration
• 2 g rms, 5 Hz to 500 kHz, 3 axes
EMC & Safety
Emissions
Harmonic Currents
Voltage Flicker
ESD Immunity
Radiated Immunity
EFT/Burst
Surge
Conducted Immunity
Dips & Interruptions
Safety Approvals
• EN55022 & EN55011, level B conducted
• EN61000-3-2
• EN61000-3-3
• EN61000-4-2, level 2 Perf Criteria A
• EN61000-4-3, level 3 Perf Criteria A
• EN61000-4-4, level 3 Perf Criteria A
• EN61000-4-5, installation class 3
Perf Criteria A
• EN61000-4-6, level 3 Perf Criteria A
• EN61000-4-11, 30% 10 ms,
60% 100 ms, 100% 5000 ms
Perf Criteria A, B, B
• UL60950-1