|
PBM300PS03-C Datasheet, PDF (1/2 Pages) XP Power Limited – AC-DC Power Supplies | |||
|
300 Watts
PBM300 Series
xppower.com
⢠Worldwide Medical Approvals
⢠Single and Quad Outputs
⢠Small Size - Only 7.50â x 4.50â x 1.75â
⢠Power Fail Detect & Remote On/Off
⢠Universal AC Input with Active PFC
⢠High Reliability >300 kHrs MTBF
⢠150 Watt Convection-cooled Rating
Specification
Input
Input Voltage
⢠90-264 VAC
Input Frequency
⢠47-63 Hz
Input Current
⢠4.7 A rms at 115 VAC,
2.3 A rms for 230 VAC
Inrush Current
⢠30 A at 115 VAC,
60 A at 230 VAC cold start +25 °C
Power Factor
⢠0.98 typical
Earth Leakage Current ⢠100 µA max at 115 VAC/60 Hz
220 µA max at 230 VAC/50 Hz
Input Protection
⢠Both line and neutral fused
Output
Output Voltage
⢠See table
Output Voltage Trim ⢠±5% for outputs 1 & 2
Initial Set Accuracy ⢠±2%
Minimum Load
⢠See table and note 5
Start Up Delay
⢠2 s max
Start Up Rise Time
⢠18 ms typical
Hold Up Time
⢠12 ms min at full load and 110 VAC
Drift
⢠±0.2%
Line Regulation
⢠±0.2% max
Load Regulation
⢠See note 6
Transient Response
⢠4% max deviation, recovery to within
1% in 500 µs for a 25% load change
Ripple & Noise
⢠2% max pk-pk, 20 MHz BW, with a 22 µF
electrolytic & a 0.47 µF tantalum capacitor
Overvoltage Protection ⢠115-140% Vnom output 1 only, recycle
input to reset
Overtemperature
Protection
⢠Shutdown at +95 °C (singles) or +105 °C
(multi-outputs) with auto recovery,
measured internally
Overload Protection ⢠140-200% typical, auto recovery
Short Circuit Protection ⢠Trip and restart (Hiccup mode)
Temperature
Coefficient
⢠0.04%/°C
Remote Sense
⢠Compensates for up to 0.5 V drop
Remote On/Off
⢠On = Logic low or open circuit
Off = Logic high
General
Efficiency
Isolation
Switching Frequency
Power Density
Power Fail Detect
MTBF
⢠70% typical
⢠4000 VAC Input to Output
1500 VAC Input to Ground
500 VAC Output to Ground
⢠70 kHz ±10 kHz
⢠5.08 W/In3
⢠AC OK = TTL logic high
AC not OK = TTL logic low
⢠300 kHrs per MIL-HDBK-217F at +25 °C
Environmental
Operating Temperature ⢠0 °C to +70 °C, derate linearly from 100%
power at +50 °C to 50% power at +70 °C
Cooling
⢠âCâ versions have internal fan,
âBâ versions are derated with convection
cooling or require 35 CFM (see note 4)
Operating Humidity ⢠up to 95% RH, non-condensing
Storage Temperature ⢠-40 °C to +85 °C
Operating Altitude
⢠2500 m
Shock
⢠Half sine pulse. acceleration 50 g,
duration 11 ms, 3 shocks in each
direction, unpackaged, non-operating
Vibration
⢠Sinusoidal 10-50 Hz, amplitude 0.15 mm,
30 min/axis, unpackaged, non-operating
EMC & Safety
Emissions
Harmonic Currents
Voltage Flicker
ESD Immunity
Radiated Immunity
EFT/Burst
Surge
Conducted Immunity
Dips & Interruptions
Safety Approvals
⢠EN55011 and FCC Class B conducted
& radiated
⢠EN61000-3-2
⢠EN61000-3-3
⢠EN61000-4-2, level 3 Perf Criteria A
⢠EN61000-4-3, level 3 Perf Criteria A
⢠EN61000-4-4, level 3 Perf Criteria A
⢠EN61000-4-5, level 3 Perf Criteria A
⢠EN61000-4-6, 3 V Perf Criteria A
⢠EN61000-4-11, 30% 10 ms,
60% 100 ms, >95% 5000 ms,
Perf Criteria A, A, B
⢠EN60601-1, UL60601-1,
CSA22.2 No. 601-1 per cUL, CE Mark
|
▷ |