|
JTH15 Datasheet, PDF (1/2 Pages) XP Power Limited – 15 Watts JTH Series | |||
|
15 Watts
JTH Series
xppower.com
⢠4:1 Input Range
⢠1500 VDC Isolation
⢠Efficiency up to 86%
⢠40 °C to +100 °C Operating Temperature
⢠Optional Remote On/Off
⢠Single & Dual Outputs
⢠3 Year Warranty
Specification
Input
Input Voltage Range
Input Current
Input Filter
Input Reflected
Ripple Current
Input Surge
Undervoltage Lockout
⢠24 V (9-36 VDC)
48 V (18-72 VDC)
⢠See table
⢠Pi network
⢠35 mA rms through 12 µH inductor
⢠24 V models 40 VDC for 100 ms
48 V models 80 VDC for 100 ms
⢠24 V models ON 8.6 V, OFF 8 VDC typical
48 V models ON 16.0 V, OFF 14 V typical
Output
Output Voltage
⢠See table
Minimum Load
⢠No minimum load required
Line Regulation
⢠±0.5%
Load Regulation
⢠±0.5% 10-100% load,
±1.0% 10% load
Cross Regulation
⢠±5% on dual output models (see note 3)
Setpoint Accuracy
⢠±1%
Start Up Delay
⢠<10 ms
Start Up Rise Time
⢠<20 ms
Ripple & Noise
⢠75 mV pk-pk 20 MHz bandwidth
Transient Response
⢠3% max deviation, recovery to within
1% in 200 µs for 25% load change
Temperature
Coefficient
⢠0.02%/°C
Overvoltage Protection ⢠None
Overcurrent Protection ⢠140% typical of full load at nominal input
Short Circuit Protection ⢠Trip & restart (hiccup mode),
auto recovery
Remote On/Off
⢠Optional (see application note)
Maximum Capacitive ⢠See table
Load
General
Efficiency
Isolation
Isolation Resistance
Isolation Capacitance
Switching Frequency
Power Density
MTBF
⢠See table
⢠1500 VDC Input to Output
1000 VDC Input to Case
1000 VDC Output to Case
⢠109â¦
⢠1200 pF typical
⢠300 kHz typical
⢠18.75 W/in3
⢠>1.21 MHrs to MIL-HDBK-217F
at 25 °C, GB
Environmental
Operating Temperature ⢠-40 °C to +100 °C, derate from 100% load
at +60 °C to 0% load at +100 °C
Case Temperature
⢠100 °C max
Cooling
⢠Convection-cooled
Operating Humidity ⢠Up to 95% RH, non-condensing
Storage Temperature ⢠-40 °C to +125 °C
EMC
Emissions
ESD Immunity
EFT/Burst
Surge
Conducted Immunity
Magnetic Field
⢠EN55022 class A conducted &
radiated with external components,
see application note
⢠EN61000-4-2,
8 kV air discharge Perf Criteria A,
4 kV contact discharge Perf Criteria A
⢠EN61000-4-4, level 1 Perf Criteria A*
⢠EN61000-4-5, installation class 1,
Perf Criteria A*
⢠EN61000-4-6, 3 Vrms Perf Criteria A
⢠EN61000-4-8, 1 A/m Perf Criteria A
*External input capacitor required 220 µF/100 V
|
▷ |