|
JCK3024S05 Datasheet, PDF (1/2 Pages) XP Power Limited – 2 1 Input Range | |||
|
30 Watts
JCK30 Series
xppower.com
⢠2:1 Input Range
⢠High Power Density
⢠Single and Dual Outputs
⢠High Efficiency Up to 92%
⢠Remote On/Off
⢠1600 VDC Isolation
⢠3 Year Warranty
Specification
Input
Input Voltage Range
Input Current
Undervoltage Lockout
Input Surge
⢠12 V (9-18 VDC),
24 V (18-36 VDC),
48 V (36-75 VDC)
⢠See table
⢠12 V models: ON 8.6 V, OFF 7.9 V typical
24 V models: ON 17.8 V, OFF 16 V typical
48 V models: ON 33.5 V, OFF 30.5 V typical
⢠12 V models 25 VDC for 100 ms
24 V models 50 VDC for 100 ms
48 V models 100 VDC for 100 ms
Output
Output Voltage
⢠See table
Output Voltage Trim ⢠±10% on single outputs models only
Minimum Load
⢠No minimum load required
Line Regulation
⢠±0.5% max
Load Regulation
⢠Single output models: ±0.5% max
Dual output models: ±1% max
balanced outputs
Cross Regulation
⢠±5%, see note 2
Setpoint Accuracy
⢠±1%
Start Up Time
⢠30 ms typical
Ripple & Noise
⢠100 mV or 1% pk-pk, whichever is
greater,
20 MHz bandwidth, see note 3
Transient Response
⢠3% max deviation, recovery to within
1% in <250 µs for a 25% load change
Temperature
Coefficient
⢠0.02%/ËC
Overvoltage Protection ⢠3.3 V models: 3.9 V typical
5 V models: 6.2 V typical
12 V models: 15 V typical
15 V models: 18 V typical
±5 V models: ±6.2 V typical
±12 V models: ±15 V typical
±15 V models: ±18 V typical
Overload Protection ⢠>150%
Short Circuit Protection ⢠Trip & restart (Hiccup mode),
auto recovery
Remote On/Off
⢠On = Logic High (>3.0) or Open
Off = Logic Low (<1.2 V) or short pin 2
to 3
General
Efficiency
Isolation
Isolation Capacitance
Switching Frequency
MTBF
⢠See table
⢠1600 VDC Input to Output
1600 VDC Input to Case
1600 VDC Output to Case
⢠1500 pF typical
⢠330 kHz typical
⢠430 kHrs min to MIL-HDBK-217F
at 25 ËC, GB
Environmental
Operating Temperature ⢠-40 ËC to +75 ËC, see derating curve
Case Temperature
⢠+105 ËC max
Cooling
⢠Convection-cooled
Operating Humidity ⢠5-95% RH, non-condensing
Storage Temperature ⢠-40 ËC to +125 ËC
|
▷ |