AEM60 Datasheet, PDF (1/2 Pages) XP Power Limited – Worldwide Medical Approvals

60 Watts
AEM60 Series
xppower.com
• CEC 2008 & EISA 2007 Compliant 12 V
• Worldwide Medical Approvals
• 4000 VAC Isolation
• Class II Construction
• Single Outputs from 5 V to 48 V
• High Efficiency
• 3 Year Warranty
Specification
Input
Input Voltage
Input Frequency
Input Current
Inrush Current
Input Protection
No Load Input Power
• 80-264 VAC, derate output power 5%
<90 VAC and 10% <85 VAC
• 47-63 Hz
• 1.5 A rms max
• 80 A max at 240 VAC
• Fitted with a T2 A/250 VAC fuse in live line
• <0.5 W for ≥12 V output
Output
Output Voltage
• See table
Initial Set Accuracy • See table
Minimum Load
• No mimimum load required
Start Up Delay
• 3 s max
Start Up Rise Time
• 3 ms
Hold Up Time
• 8 ms minimum at 115 VAC
Line Regulation
• ±1%
Load Regulation
• See table
Transient Response
• 5% max deviation recovering to within 1%
within 500 µs for 50% load change
Ripple & Noise
• 1% max, 20 MHz bandwidth (see note 2)
Overvoltage Protection • See table
Overload Protection
• 120-150%, trip & restart (hiccup mode),
auto-recovery
Short Circuit Protection • Continuous
Temperature
Coefficient
• ±0.05%/°C
General
Efficiency
Isolation
Switching Frequency
Power Density
MTBF
• 85%, see note 5
• 4000 VAC Input to Output
• 100 kHz typical
• 4.2 W/Inch³
• 300 kHrs to MIL-HDBK-217F
at 25 ˚C, GB
Environmental
Operating Temperature • 0 °C to +60 °C, derate linearly from 100%
load at +40 °C to 50% load at +60 °C
Cooling
• Convection-cooled
Operating Humidity • 15-95% non-condensing
Storage Temperature • -20 °C to +85 °C
Operating Altitude
• 3000 m
Vibration
• 5-500 Hz at 3 g for 10 mins on each axis
Shock
• 30 g with 18 ms half sine wave,
3 times on each axis
EMC & Safety
Emissions
Harmonic Currents
Voltage Flicker
ESD Immunity
Radiated Immunity
EFT/Burst
Surge
Conducted Immunity
Dips & Interruptions
Safety Approvals
• EN55011 Level B conducted & radiated
• EN61000-3-2, class A
• EN61000-3-3
• EN61000-4-2 Level 3, Perf Criteria A
• EN61000-4-3 Level 2, Perf Criteria A
• EN61000-4-4, Level 3, Perf Criteria A
• EN61000-4-5 Level 3, Perf Criteria A
• EN61000-4-6 Level 3, Perf Criteria A
• EN61000-4-11, 30% 10 ms, 60% 100 ms,
100% 5000 ms Perf Criteria A, B, B
• UL60601-1, EN60601-1, IEC60601-1,
CE Mark