X25640 Datasheet, PDF (8/14 Pages) Xicor Inc. – Advanced SPI Serial E2PROM With Block LockTM Protection

X25640
ABSOLUTE MAXIMUM RATINGS*
Temperature under Bias .................. –65°C to +135°C
Storage Temperature ....................... –65°C to +150°C
Voltage on any Pin with Respect to V_SS ......... –1V to +7V
D.C. Output Current ............................................. 5mA
Lead Temperature
(Soldering, 10 seconds) .............................. 300°C
*COMMENT
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation of
the device at these or any other conditions above those
listed in the operational sections of this specification is
not implied. Exposure to absolute maximum rating con-
ditions for extended periods may affect device reliability.
RECOMMENDED OPERATING CONDITIONS
Temp
Commercial
Industrial
Military
Min.
0°C
–40°C
–55°C
Max.
+70°C
+85°C
+125°C
3089 PGM T06.1
Supply Voltage
X25640
Limits
5V ±10%
3089 PGM T07.1
D.C. OPERATING CHARACTERISTICS (Over the recommended operating conditions unless otherwise specified.)
Limits
Symbol Parameter
I_CC V_CC Supply Current (Active)
Min.
Max.
5
Units
mA
I_SB* V_CC Supply Current (Standby)
200
µA
V_OH2
I_LI
I_LO
V_IL(1)
V_IH(1)
V_OL
V_OH1
Output High Voltage
Input Leakage Current
Output Leakage Current
Input LOW Voltage
Input HIGH Voltage
Output LOW Voltage
Output HIGH Voltage
V_CC – 0.4
V
10
µA
10
µA
–1 V_CC x 0.3 V
V_CC x 0.7 V_CC + 0.5 V
0.4
V
V_CC–0.8
V
*I_SB is measured after a 2 second settling time upon initial power up.
Test Conditions
SCK = V_CC x 0.1/V_CC x 0.9 @ 1MHz,
SO = Open, CS = V_SS
CS = V_CC, V_IN = V_SS or V_CC – 0.3V
V_CC = 5.5V
I_OH = –0.4mA
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC
I_OL = 2mA
I_OH = –1mA
3089 PGM T08.3
POWER-UP TIMING
Symbol
t_PUR(3)
t_PUW(3)
Parameter
Power-up to Read Operation
Power-up to Write Operation
Min.
Max.
1
5
Units
ms
ms
3089 PGM T09
CAPACITANCE T_A = +25°C, f = 1MHz, V_CC = 5V.
Symbol
Test
Max.
Units
Conditions
C_OUT(2)
Output Capacitance (SO)
8
pF
C_IN(2)
Input Capacitance (SCK, SI, CS, WP, HOLD)
6
pF
V_OUT = 0V
V_IN = 0V
Notes:
(1) V_IL min. and V_IH max. are for reference only and are not tested.
(2) This parameter is periodically sampled and not 100% tested.
3089 PGM T10.1
(3) t_PUR and t_PUW are the delays required from the time V_CC is stable until the specified operation can be initiated. These parameters
are periodically sampled and not 100% tested.
8