X9430 Datasheet, PDF (12/21 Pages) Xicor Inc. – Dual Digitally Controlled Potentiometer (XDCP™) with Operational Amplifier

X9430 – Preliminary Information
POTENTIOMETER D.C. OPERATING CHARACTERISTICS
(Over the recommended operating conditions unless otherwise specified.)
Symbol
Parameter
I_CC1 V_CC supply current (active)
I_CC2
I_SB
I_LI
I_LO
V_IH
V_IL
V_OL
V_CC supply current (nonvolatile
write)
V_CC current (standby)
Input leakage current
Output leakage current
Input HIGH voltage
Input LOW voltage
Output LOW voltage
Min.
Limits
Typ. Max.
400
1
V_CC x 0.7
–0.5
1
10
10
V_CC + 0.5
V_CC x 0.1
0.4
Unit
µA
mA
µA
µA
µA
V
V
V
Test Conditions
f_SCK = 2MHz, SO = Open,
Other Inputs = V_SS
f_SCK = 2MHz, SO = Open,
Other Inputs = V_SS
SCK = SI = V_SS, Addr. = V_SS
V_IN = V_SS to V_CC
V_OUT = V_SS to V_CC
I_OL = 3mA
ENDURANCE AND DATA RETENTION
Parameter
Minimum endurance
Data retention
Min.
100,000
100
Unit
Data changes per register
years
CAPACITANCE
Symbol
C_OUT⁽⁵⁾
C_IN⁽⁵⁾
C_L | C_H | C_W
Test
Output capacitance (SO)
Input capacitance (A0, A1, SI, WP, HOLD and SCK)
Potentiometer capacitance
Typ.
10/10/
Max.
8
6
Unit
pF
pF
pF
Test Conditions
V_OUT = 0V
V_IN = 0V
POWER-UP TIMING
Symbol
t_PUR⁽⁶⁾
t_PUW⁽⁶⁾
Parameter
Power-up to initiation of read operation
Power-up to initiation of write operation
Max.
1
5
Unit
ms
ms
A.C. TEST CONDITIONS
Input pulse levels
Input rise and fall times
Input and output timing level
V_CC x 0.1 to V_CC x 0.9
10ns
V_CC x 0.5
Notes: (5) This parameter is periodically sampled and not 100%
tested.
(6) t_PUR and t_PUW are the delays required from the time the
third (last) power supply (V_CC, V+ or V-) is stable until
the specific instruction can be issued. These parameters
are
periodically sampled and not 100% tested.
(7) The power-up order of power supplies are V_CC, V+
and V-.
SPICE Macro Model
R_TOTAL
R_H
R_L
C_H
C_W
C_L
R_W
REV 1.0 6/20/00
www.xicor.com
Characteristics subject to change without notice. 12 of 21