784776227 Datasheet, PDF (6/7 Pages) Wurth Elektronik GmbH & Co. KG, Germany. – WE-PD2A SMD Power Inductor

I Cautions and Warnings:
The following conditions apply to all goods within the product series of WE-PD2A
of Würth Elektronik eiSos GmbH & Co. KG:
General:
All recommendations according to the general technical specifications of the data sheet have to be complied with.
The usage and operation of the product within ambient conditions, which probably alloy or harm the wire isolation, has to be avoided.
If the product is potted in costumer applications, the potting material might shrink during and after hardening. The product is exposed to the
pressure of the potting material with the effect that the core, wire and termination is possibly damaged by this pressure and so the electrical
as well as the mechanical characteristics are endangered to be affected. After the potting material is cured, the core, wire and termination of
the product have to be checked if any reduced electrical or mechanical functions or destructions have occurred.
The responsibility for the applicability of customer specific products and use in a particular customer design is always within the authority of
the customer. All technical specifications for standard products do also apply to customer specific products.
Washing varnish agent that is used during the production to clean the customer application might damage or change the characteristics of the
wire insulation, the marking or the plating. The washing varnish agent could have a negative effect on the long term function of the product.
Direct mechanical impact to the product shall be prevented as the ferrite material of the core could flake or in the worst case it could break.
Product specific:
Follow all instructions mentioned in the data sheet, especially:
•The soldering profile has to be complied with according to the technical reflow soldering specification, otherwise this will void the
warranty.
•All products shall be used before the end of the period of 12 months based on the product date code, if not a 100% solderability can´t be
ensured.
•Violation of the technical product specifications such as exceeding the nominal rated current will void the warranty.
•Solvents may influence the product marking.
The general and product specific cautions comply with the state of the scientific and technical knowledge and are believed to be accurate and
reliable; however, no responsibility is assumed for inaccuracies or incompleteness.
DESCRIPTION
2.3
2015-01-07
SSt
BMoe
2.2
2014-05-19
SSt
BMoe
WE-PD2A SMD Power Inductor
2.1
2014-03-12
SSt
BMoe
Würth Elektronik eiSos GmbH & Co. KG
2.0
2014-02-03
SSt
BMoe
EMC & Inductive Solutions
Max-Eyth-Str. 1
1.7
2013-12-05
SSt
BMoe
74638 Waldenburg
Germany
Order.- No.
SIZE
1.6
2013-10-10
SSt
1.5
2013-04-10
SSt
BMoe
SSt
Tel. [phone] - 0
www.we-online.com
784776227
A4
[e-mail]
REV
DATE
BY
CHECKED
Size: 1054
This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use.
Moreover Würth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Würth Elektronik eiSos GmbH & Co KG must be informed about the intent of such usage before
the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.