7448040707 Datasheet, PDF (4/6 Pages) Wurth Elektronik GmbH & Co. KG, Germany. – WE-CMBNC Common Mode Power Line Choke Nanocrystalline

H Soldering Specifications:
H4: Classification Wave Soldering Profile:
H5: Classification Wave Profile
Profile Feature
Preheat
- Temperature Min (Tsmin)
- Temperature Typical (Tstypical)
- Temperature Max (Tsmax)
- Time (ts) from (Tsmin to Tsmax)
Δ preheat to max Temperature
Peak temperature (Tp)
Time of actual peak temperature (tp)
Ramp-down rate
- Min
- Typical
- Max
Pb-Free Assembly
100°C
120°C
130°C
70 seconds
150°C max.
250°C - 260°C
max. 10 seconds
max. 5 second each wave
~ 2 K/s
~ 3.5 K/s
~ 5 K/s
Time 25°C to 25°C
refer to EN 61760-1:2006
4 minutes
Sn-Pb Assembly
100°C
120°C
130°C
70 seconds
150°C max.
235°C - 260°C
max. 10 seconds
max. 5 second each wave
~ 2 K/s
~ 3.5 K/s
~ 5 K/s
4 minutes
DESCRIPTION
2.1
2016-05-25
KaS
HasA
2.0
2016-02-16
KaS
SRe
Würth Elektronik eiSos GmbH & Co. KG
1.3
2015-02-16
SSt
HasA
EMC & Inductive Solutions
Max-Eyth-Str. 1
1.2
2014-05-13
SSt
SSt
74638 Waldenburg
1.1
2014-04-02
SSt
Germany
HasA
Tel. [phone] - 0
1.0
2014-03-17
SSt
HasA
www.we-online.com
[e-mail]
REV
DATE
BY
CHECKED
WE-CMBNC Common Mode Power Line
Choke Nanocrystalline
Order.- No.
SIZE
7448040707
A4
Size: Type L
This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use.
Moreover Würth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Würth Elektronik eiSos GmbH & Co KG must be informed about the intent of such usage before
the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.