7448011008 Datasheet, PDF (1/6 Pages) Wurth Elektronik GmbH & Co. KG, Germany. – WE-CMBNC Common Mode Power Line Choke Nanocrystalline

A Dimensions: [mm]
B Recommended hole pattern: [mm]
C Schematic:
D Electrical Properties:
Properties
Test conditions
Inductance
10 kHz/ 0.1 mA
L
Rated current
@ 70°C
IR
DC Resistance
@ 20°C
RDC
Rated voltage
50 Hz
UR
Insulation test voltage 50 Hz/ 5 mA/ 2 sec. UT
Value
2x 8.0
1.0
2x 330
250
1500
Unit
mH
A
mΩ
V (AC)
V (AC)
Tol.
+50%/-30%
max.
max.
max.
E General information:
It is recommended that the temperature of the part does
not exceed +125°C under worst case conditions.
•Storage Temperature: -20°C to 60°C
•Operating Temperature: -40°C to 125°C
•Temperature Rise: < 55K
•Test conditions of Electrical Properties: 20°C, 33% RH
if not specified differently
DESCRIPTION
Würth Elektronik eiSos GmbH & Co. KG
1.3
2015-02-16
SSt
HasA
EMC & Inductive Solutions
Max-Eyth-Str. 1
1.2
2014-05-13
SSt
SSt
74638 Waldenburg
1.1
2014-04-02
SSt
Germany
HasA
Tel. [phone] - 0
1.0
2014-03-17
SSt
HasA
www.we-online.com
[e-mail]
REV
DATE
BY
CHECKED
WE-CMBNC Common Mode Power Line
Choke Nanocrystalline
Order.- No.
SIZE
7448011008
A4
Size: Type XS
This electronic component has been designed and developed for usage in general electronic equipment only. This product is not authorized for use in equipment where a higher safety standard and reliability standard is especially required or where a failure of the product is reasonably expected to cause severe personal injury or death, unless the parties have executed an agreement specifically governing such use.
Moreover Würth Elektronik eiSos GmbH & Co KG products are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship control), transportation signal, disaster prevention, medical, public information network etc.. Würth Elektronik eiSos GmbH & Co KG must be informed about the intent of such usage before
the design-in stage. In addition, sufficient reliability evaluation checks for safety must be performed on every electronic component which is used in electrical circuits that require high safety and reliability functions or performance.