EV20D130K-JSIX Datasheet, PDF (4/59 Pages) World Produts Inc. – Metal Oxide Varistors

Metal Oxide Varistors - EV Series
Definition of Terms (according to IEEE specifications C62.33)
Average Power Dissipation: Tested using two consecutive pulses at rated peak current using a 10/1000µs test
waveform with a minimum pulse period of 60 seconds between pulses (IEC 61000-4-5).
Rated RMS Voltage, Rated DC Voltage: The maximum designated values of power system voltage that may be applied
continuously between the terminals of a device.
Varistor Voltage: Test characteristic that is used to classify varistors by type. A test current of 1mA DC is typically
used to determine varistor voltage classification type. Varistor voltage clamping characteristics can be defined
at various test levels.
Rated Peak Single Pulse Transient Current: Maximum surge current, 8/20μs waveform which a varistor is rated to
withstand for a single surge.
Rated Single Pulse Transient Energy: Maximum allowable energy for a single impulse (see specified waveforms).
Maximum Clamping Voltage: Measured peak voltage across the device terminals when a current impulse of specified
amplitude and waveform is conducted through the varistor.
Typical Capacitance: Typical capacitance values are measured at a test frequency of 1KHZ.
General Characteristics
Storage Temperature
Operating Surface Temperature
Operating Ambient Temperature
Maximum Voltage-Temperature
Coefficient
Insulation Resistance
Hi POT (Leads to Case, 1 min.)
Typical Response Time
Epoxy Rating
Current/Energy Derating (>85°C)
DC Leakage Current
Solderability
Failure Criteria
- 55° C to + 125° C
125° C
- 55° C to + 85° C (without derating)
< -0.01 % / °C
1000 Megohm min.
3000 VDC*
< 15 nsec.
94 V-0
- 2.5 % / °C
200µA Max (at rated DC working voltage)
MIL STD 202G, Method 208H
Voltage change ± 10% from initially measured Varistor Voltage. When
determining if varistor is within aforementioned criteria the same temperature
must be observed as was used for initial Varistor Voltage measurements.
*Rating is for standard epoxy, for flame retardant coating (suffix “S”) disk sizes 5mm to 20mm rating is 2000 VDC, for disk
sizes 22mm & 34mm rating is 2500VDC.
WORLD PRODUCTS INC. 19654 Eighth Street East, Sonoma, CA 95476 | Phone [phone] | Fax [phone] | www.worldproducts.com
2 | Metal Oxide Varistors - EV Series
Rev. 3.1