WM8980_12 Datasheet, PDF (90/123 Pages) Wolfson Microelectronics plc – Stereo CODEC with Speaker Driver and Video Buffer

WM8980
Pre-Production
Notes:
1. The analogue input pin charge time, t_{midrail_on,} is determined by the VMID pin charge time. This
time is dependent upon the value of VMID decoupling capacitor and VMID pin input resistance
and AVDD power supply rise time.
2. The analogue input pin discharge time, t_{midrail_off,} is determined by the analogue input coupling
capacitor discharge time. The time, t_{midrail_off}, is measured using a 1μF capacitor on the analogue
input but will vary dependent upon the value of input coupling capacitor.
3. While the ADC is enabled there will be LSB data bit activity on the ADCDAT pin due to system
noise but no significant digital output will be present.
4. The VMIDSEL and BIASEN bits must be set to enable analogue input midrail voltage and for
normal ADC operation.
5. ADCDAT data output delay from power –p - with power supplies starting from –V - is determined
primarily by the VMID charge time. ADC initialisation and power management bits may be set
immediately after POR is released; VMID charge time will be significantly longer and will dictate
when the device is stabilised for analogue input.
6. ADCDAT data output delay at power up from device standby (power supplies already applied) is
determined by ADC initialisation time, 2/fs.
Figure 54 DAC Power Up and Down Sequence (not to scale)
w
PP, Rev 3.8, May 2012
90