WM8985_07 Datasheet, PDF (55/118 Pages) Wolfson Microelectronics plc – Multimedia CODEC With Class D Headphone and Line Out

Pre-Production
WM8985
Figure 23 DAC Digital Filter Path
The analogue outputs from the DACs can then be mixed with the aux analogue inputs and the ADC
analogue inputs. The mix is fed to the output drivers for headphone (LOUT1/ROUT1,
LOUT2/ROUT2) or line (OUT3/OUT4). OUT3 and OUT4 have additional mixers which allow them to
output different signals to the line outputs or back into the record path.
DIGITAL PLAYBACK (DAC) PATH
Digital data is passed to the WM8985 via the flexible audio interface and is then passed through a
variety of advanced digital filters as shown in Figure 23 to the hi-fi DACs. The DACs are enabled by
the DACENL/R register bits.
REGISTER
ADDRESS
R3 (03h)
Power
Management 3
BIT LABEL
0
DACENL
1
DACENR
Table 21 DAC Enable Control
DEFAULT
DESCRIPTION
0
Left channel DAC enable
0 = DAC disabled
1 = DAC enabled
0
Right channel DAC enable
0 = DAC disabled
1 = DAC enabled
The WM8985 also has a Soft Mute function, which when enabled, gradually attenuates the volume
of the digital signal to zero. When disabled, the gain will ramp back up to the digital gain setting. This
function is enabled by default. To play back an audio signal, it must first be disabled by setting the
SOFTMUTE bit to zero.
REGISTER
ADDRESS
R10 (0Ah)
DAC Control
BIT
LABEL
0 DACPOL
1 DACRPOL
2 AMUTE
3 DACOSR128
6 SOFTMUTE
Table 22 DAC Control Register
DEFAULT
0
0
0
0
0
DESCRIPTION
Left DAC output polarity:
0 = non-inverted
1 = inverted (180 degrees phase shift)
Right DAC output polarity:
0 = non-inverted
1 = inverted (180 degrees phase shift)
Automute enable
0 = Amute disabled
1 = Amute enabled
DAC oversampling rate:
0 = 64x (lowest power)
1 = 128x (best performance)
Softmute enable:
0 = Enabled
1 = Disabled
w
PP, Rev 3.5, January 2007
55