ISD1600B Datasheet, PDF (9/23 Pages) Winbond – Single-Message Single-Chip 6.6- to 40-Second Voice Record & Playback Devices with vAlert Option

ISD1600B SERIES
6. FUNCTIONAL DESCRIPTION
6.1. DETAILED DESCRIPTION
6.1.1 Audio Quality
Winbond’s patented ChipCorder^® MLS technology provides natural high quality record and
playback solution on a single chip. The input audio signals are stored directly into the non-
volatile memory and are reproduced in its natural form without any compression artifacts
caused by the digital speech solutions. A complete sample is stored in a single cell,
minimizing the memory needed to store a single message.
6.1.2 Duration
The ISD1600B series offer single-chip solution with record & playback duration from 6.6
seconds to 40 seconds. Sampling frequency and duration are determined by an external
resistor connected to the Rosc pin.
Sampling Frequency
12 KHz
8 KHz
6.4 KHz
5.3 KHz
4 KHz
Rosc
53 kΩ
80 kΩ
100 kΩ
120 kΩ
160 kΩ
ISD1610B
6.6 secs
10 secs
12.5 secs
15 secs
20 secs
ISD1612B
8 secs
12 secs
15 secs
18 secs
24 secs
ISD1616B
10.6 secs
16 secs
20 secs
24 secs
32 secs
ISD1620B
13.3 secs
20 secs
25 secs
30 secs
40 secs
6.1.3 Flash Storage
The ISD1600B product utilizes the on-chip Flash memory providing zero-power message
storage. The message is retained for up to 100 years without power. In addition, the device
can be re-recorded typically over 100,000 times.
6.1.4 Basic Operation
The ISD1600B ChipCorder^® device is controlled by either the REC , or one of the two
playback modes, PLAYE and PLAYL . The ISD1600B parts are configured for simple design
in single-message application. Detailed operations are explained in Section 6.2.
6.1.5 vAlert
With vAlert option, after Record, the LED blinks slowly to indicate a new message exists.
Once playback is performed, the LED will not blink again and resume to normal operating
conditions.
6.1.6 Automatic Power-Down Mode
At the end of a playback or record cycle, the ISD1600B device automatically enters into a low-
power mode, consuming typically 1µA, provided that PLAYE , PLAYL and REC are High
(see DC parameters Section). During a playback cycle, the device powers down automatically
Publication Release Date: Jan. 23, 2007
-9-
Revision 1.2