W25Q80BV Datasheet, PDF (66/75 Pages) Winbond – 8M-BIT SERIAL FLASH MEMORY WITH DUAL AND QUAD SPI

W25Q80BV
10.7 AC Electrical Characteristics (cont’d)
DESCRIPTION
SPEC
SYMBOL ALT
MIN TYP
MAX
UNIT
/HOLD Active Hold Time relative to CLK
tCHHH
5
ns
/HOLD Not Active Setup Time relative to CLK
tHHCH
5
ns
/HOLD Not Active Hold Time relative to CLK
/HOLD to Output Low-Z
/HOLD to Output High-Z
Write Protect Setup Time Before /CS Low
Write Protect Hold Time After /CS High
/CS High to Power-down Mode
/CS High to Standby Mode without Electronic Signature
Read
/CS High to Standby Mode with Electronic Signature
Read
/CS High to next Instruction after Suspend
tCHHL
tHHQX⁽²⁾
tHLQZ⁽²⁾
tWHSL⁽³⁾
tSHWL⁽³⁾
tDP⁽²⁾
tRES1⁽²⁾
5
tLZ
tHZ
20
100
tRES2⁽²⁾
tSUS⁽²⁾
ns
7
ns
12
ns
ns
ns
3
µs
3
µs
1.8
µs
20
µs
Write Status Register Time
tW
Byte Program Time (First Byte) ⁽⁴⁾
t_BP1
Additional Byte Program Time (After First Byte) ⁽⁴⁾
t_BP2
Page Program Time
tPP
Sector Erase Time (4KB)
tSE
10
15
ms
30
50
µs
2.5
12
µs
0.7
3
ms
30 200/400⁽⁵⁾ ms
Block Erase Time (32KB)
Block Erase Time (64KB)
Chip Erase Time
tBE₁
120
800
ms
tBE₂
150 1,000
ms
tCE
2
6
s
Notes:
1.
2.
3.
4.
5.
Clock high + Clock low must be less than or equal to 1/fC.
Value guaranteed by design and/or characterization, not 100% tested in production.
Only applicable as a constraint for a Write Status Register instruction when SRP[1:0]=(0,1).
For multiple bytes after first byte within a page, t_BPN = t_{BP1 +} t_{BP2 * N} (typical) and t_BPN = t_{BP1 +} t_{BP2 * N} (max), where N =
number of bytes programmed.
Max Value t_SE with <50K cycles is 200ms and >50K & <100K cycles is 400ms.
- 66 -