|
W25Q32DW Datasheet, PDF (35/82 Pages) Winbond – 1.8V 32M-BIT SERIAL FLASH MEMORY WITH DUAL/QUAD SPI & QPI | |||
|
◁ |
W25Q32DW
/CS
CLK
Mode 3
Mode 0
IO0
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
A23-16 A15-8
A7-0
M7-0 Dummy Dummy
IOs switch from
Input to Output
20 16 12 8 4 0 4 0
40404
IO1
21 17 13 9 5 1 5 1
51515
IO2
22 18 14 10 6 2 6 2
62626
IO3
23 19 15 11 7 3 7 3
73
Byte 1
73
Byte 2
7
Byte 3
Figure 15b. Fast Read Quad I/O Instruction (Previous instruction set M5-4 = 10, SPI Mode)
Fast Read Quad I/O with â8/16/32/64-Byte Wrap Aroundâ in Standard SPI mode
The Fast Read Quad I/O instruction can also be used to access a specific portion within a page by
issuing a âSet Burst with Wrapâ (77h) command prior to EBh. The âSet Burst with Wrapâ (77h) command
can either enable or disable the âWrap Aroundâ feature for the following EBh commands. When âWrap
Aroundâ is enabled, the data being accessed can be limited to either a 8, 16, 32 or 64-byte section of a
256-byte page. The output data starts at the initial address specified in the instruction, once it reaches the
ending boundary of the 8/16/32/64-byte section, the output will wrap around to the beginning boundary
automatically until /CS is pulled high to terminate the command.
The Burst with Wrap feature allows applications that use cache to quickly fetch a critical address and then
fill the cache afterwards within a fixed length (8/16/32/64-byte) of data without issuing multiple read
commands.
The âSet Burst with Wrapâ instruction allows three âWrap Bitsâ, W6-4 to be set. The W4 bit is used to
enable or disable the âWrap Aroundâ operation while W6-5 are used to specify the length of the wrap
around section within a page. See 10.2.19 for detail descriptions.
- 35 -
Publication Release Date: January 18, 2011
Preliminary - Revision C
|
▷ |