W25X10A Datasheet, PDF (31/45 Pages) Winbond – 1M-BIT, 2M-BIT, 4M-BIT AND 8M-BIT SERIAL FLASH MEMORY WITH 4KB SECTORS AND DUAL OUTPUT SPI

W25X10A, W25X20A, W25X40A, W25X80A
11. ELECTRICAL CHARACTERISTICS⁽¹⁾
11.1 Absolute Maximum Ratings ⁽²⁾
PARAMETERS
Supply Voltage
SYMBOL
VCC
Voltage Applied to Any Pin
VIO
Transient Voltage on any Pin
VIOT
Storage Temperature
Lead Temperature
Electrostatic Discharge Voltage
TSTG
TLEAD
VESD
CONDITIONS
Relative to Ground
<20nS Transient
Relative to Ground
Human Body Model⁽⁴⁾
RANGE
–0.6 to +4.0
–0.6 to VCC +0.4
–2.0V to VCC+2.0V
–65 to +150
See Note ⁽³⁾
–2000 to +2000
UNIT
V
V
V
°C
°C
V
Notes:
1. Specification for W25X10A, W25X20A, W25X40A and W25X80A is preliminary. See preliminary
designation at the end of this document.
2. This device has been designed and tested for the specified operation ranges. Proper operation
outside of these levels is not guaranteed. Exposure to absolute maximum ratings may affect device
reliability. Exposure beyond absolute maximum ratings may cause permanent damage.
3. Compliant with JEDEC Standard J-STD-20C for small body Sn-Pb or Pb-free (Green) assembly
and the European directive on restrictions on hazardous substances (RoHS) 2002/95/EU.
4. JEDEC Std JESD22-A114A (C1=100 pF, R1=1500 ohms, R2=500 ohms).
11.2 Operating Ranges
PARAMETER
SYMBOL CONDITIONS
Supply Voltage⁽¹⁾
Ambient Temperature,
Operating
VCC
TA
F_R0 = 75MHz, fR = 50MHz
F_R1 = 100MHz, fR = 50MHz
Commercial ⁽²⁾
Industrial
SPEC
MIN
MAX
2.7
3.6
3.0
3.6
0
+70
–40
+85
UNIT
V
°C
Note:
1. VCC voltage during Read can operate across the min and max range but should not exceed ±10%
of the programming (erase/write) voltage.
2. Commercial temperature only applies to Fast Read (F_R1) and 100K cycles endurance for 4K byte
sectors . Industrial temperature applies to all other parameters.
- 31 -
Publication Release Date: February 27, 2008
Revision B