W6810ES Datasheet, PDF (2/6 Pages) Winbond – Single Channel CODEC Mini Evaluation Board

1 Description
The W681xxxR-ES has the bare minimum for a digital telephone handset application which will allow the
designers to easily connect this small footprint daughter board to their applications. The evaluation system
targets developers of such systems as VoIP, Digital Telephony, mobile devices (wireless headsets), PBX
that would like to test and or develop with Winbond Family of Voice CODECs into a new system with
minimal or no additional analog design at all (“Plug & Play”).
2 Features
Smallest form that contain the bare minimum components to allow a handset/headset application.
It allows system developers to bypass the analog in and analog out components with a simplified
procedure.
• Prototype area for developer to hook up the side-tone resistor on board or RJ9 (hand-set jack) or
headset jack.
• The board has the resistors that will allow the maximum amplification for a 32 Ohm speaker and a
standard microphone
• All CODEC pins lead to holes that enable the developer to solder wires to connect to his system
board.
• The board is designed to minimize any outside noises for the cleanest signals possible.
3 Hardware
3.1 Power supply requirements
3V or 5V depending on the selected CODEC.
Winbond Codec Part Number Operating Voltage
W6810ES
5V
W681512ES
5V
W681310 ES
3V
Table 3.1: Power Supply ( The User needs to connect VCC and GND Pins )
VCC
GND
2