ISD-COB17 Datasheet, PDF (2/4 Pages) Winbond – The ISD-COB17xxx COB/Demo board

DESCRIPTION:
The ISD-COB17xxx is a COB/demo board for ISD1700 series. It has either an ISD17xxx die or ISD17xxx
SOIC unit assembled, where xxx represents the duration, to demonstrate the functionalities and voice
quality of the ISD1700 device. The default settings for sampling frequency and output are 8kHz and PWM
speaker outputs, respectively.
Product supported
ISD1730 / 40 / 50 / 60 / 90 / 120 / 150 / 180 / 210 / 240
where xxx represents the duration
CONTENTS OF THE KIT:
− The ISD-COB17xxx COB/Demo board
− User’s manual
Ordering Code
ISD-COB17xxx
HARDWARE CONNECTIONS:
• Connect a speaker and a power supply to the related terminals. Please ensure the polarity of the
power is correct to avoid any damages to the demo board.
• When AnaIn recording or feed-through (FT) is required, simply connect the related signal to the
AnaIn and ground points and/or connect FT jumper for FT mode.
• Speaker/AUD selection: Default setting is speaker output. If AUD is needed, remove the
connection from center pad to Sp- (Sp+) pad of J4 (J5) and re-connect the center pad to Vcc
(AUD) of J4 (J5), as shown below. Also, need to install a jumper at J8 (AUD1-AUX) for AUD output.
Vcc SP-
J4
J5
AUD SP+
OPERATIONS:
Standalone Operations:
To Record, simply press-and-hold the REC button and speak to the microphone. The LED stays on while
recording. Release Record button to stop recording.
To Playback the recorded message, pressing PLAY button once plays the message and it stops
automatically when completed. During playback, pressing PLAY button again will halt the playback
operation. While playback operation, the LED flashes.
To Erase a message, simply pressing ERASE button will erase the message when it is the 1^st or last
message.
To Forward to the next message, pressing FWD button once will advance to the next message.
September 2006
Rev 2
2/4