|
ENH104V1-350 Datasheet, PDF (1/15 Pages) White Electronic Designs Corporation – ENH104V1-350/450 Color TFT-LCD Module Features | |||
|
White Electronic Designs
Display Systems Division
ENH104V1-350/450
ENH104V1-350/450 Color TFT-LCD Module Features
GENERAL DESCRIPTION
White Electronic Designs Display Systems Division
provides optically enhanced solutions to the standard
Sharp LQ104V1DG21 color active matrix LCD module.
The ï¬rst enhancement is an index matching (IM) ï¬lm
lamination to the front surface of the display polarizer. The
IM ï¬lm is available in two surface treatments - IM/Clear and
IM/110 (a 10% diffusion).The second enhancement is the
incorporation of an enhanced light guide (ELG) providing
for up to 30% increase in brightness.
This module is composed of a color TFT-LCD panel,
driver ICs, and a backlight unit. Graphics and text can
be displayed on a 640 X 3 X 480 dot panel with 262, 144
color by supplying 18-bit data signal (6bit/color), four timing
signals, +3.3V/+5V DC supply voltage for TFT-LCD panel
driving and supply voltage for backlight.
The TFT-LCD panel used for this module is a low-reï¬ection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Optimum viewing
direction is 6 o'clock. Backlight-driving DC/AC inverter is
not built in this module.
White assumes no responsibility for any damage resulting
from the use of the device which does not comply with
the instructions and the precautions speciï¬ed in these
speciï¬cation sheets. White does assume the responsibility
for the warranty of the enhanced product.
SPECIFICATIONS
Parameter
Speciï¬cations
Display size (cm)
26 (10.4") Diagonal
Active area (mm)
211.2 (H) x 158.4 (V)
Pixel format
640 (H) x 480 (V)
(1 =R+G+B dots)
Pixel pitch (mm)
0.330 (H) x 0.330 (V)
Pixel conï¬guration
R,G,B vertical stripe
Display mode
Normally white
Unit outline dimensions (1) (mm)
265.0 (W) x 195.0 (H) x 11.5max(D)
Mass (g)
700 (max)
Surface treatment
IM/Clear (glossy) or IM/110 and hardcoat 3H
Note:
1. Excluding backlight cables. Outline dimensions shown in Fig.1
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or speciï¬cations without notice.
Original speciï¬cations created by Sharp.
September 2003
Rev. 0
1
Display Systems Division ⢠Hillsboro, OR ⢠(503) 690-2460 ⢠www.wedc.com
|
▷ |