ENH084V1-XXX Datasheet, PDF (1/16 Pages) White Electronic Designs Corporation – Color TFT-LCD Module Features

White Electronic Designs
Display Systems Division
ENH084V1-300/400
ENH084V1-300/400 Color TFT-LCD Module Features
GENERAL DESCRIPTION
Panelview provides optically enhanced solutions to the
standard Sharp LQ084V1DG21 color active matrix LCD
module. The first enhancement is an index matching (IM)
film lamination to the front surface of the display polarizer.
The IM film is available in two surface treatments - IM/Clear
and IM/110 (a 10% diffusion).The second enhancement
is the incorporation of an enhanced light guide (ELG)
providing for up to 30% increase in brightness.
This module is composed of a color TFT-LCD panel, driver
ICs, control circuit, power supply circuit and a backlight
unit. Graphics and text can be displayed on a 640 X 3
X 480 dot panel with 262, 144 color by supplying 18-bit
data signal (6bit/color), four timing signals, +3.3V/+5V
DC supply voltage for TFT-LCD panel driving and supply
voltage for backlight.
The TFT-LCD panel used for this module is a low-reflection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Optimum viewing
direction is 12 o'clock.
This module is the type of wide viewing angle and high
brightness (350cd/m²⁾. Backlight-driving DC/AC inverter is
not built in this module.
Panelview assumes no responsibility for any damage
resulting from the use of the device which does not
comply with the instructions and the precautions specified
in these specification sheets. Panelview does assume the
responsibility for the warranty of the enhanced product.
MECHANICAL SPECIFICATIONS
Parameter
Display size
Active area
Pixel format
Pixel pitch
Pixel configuration
Display mode
Unit outline dimensions (1)
Mass
Surface treatment
Specifications
21 (8.4") Diagonal
170.9 (H) x 129.6 (V)
640 (H) x 480 (V)
(1 pixel=R+G+B dots)
0.267 (H) x 0.270 (V)
R,G,B vertical stripe
Normally white
216.0 (W) x 152.4 (H) x 12.0(D)
410 ± 20
IM/Clear (glossy) or IM/110 and hardcoat 3H
Note:
1. Excluding backlight cables and mounting tabs.
Units
cm
mm
pixel
-
mm
-
-
mm
g
-
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
August 2003
Rev. 0
1
Display Systems Division • Hillsboro, OR • [phone] • www.wedc.com