English
Language : 

ENH084V1-300 Datasheet, PDF (1/16 Pages) White Electronic Designs Corporation – ENH084V1-300/400 COLOR TFT-LCD MODULE
White Electronic Designs
Display Systems Division
ENH084V1-300/400
ENH084V1-300/400 COLOR TFT-LCD MODULE
GENERAL DESCRIPTION
White Electronic Designs provides optically enhanced
solutions to the standard Sharp LQ084V1DG21 color
active matrix LCD module. The first enhancement is an
index matching (IM) film lamination to the front surface of
the display polarizer. The IM film is available in two surface
treatments - IM/Clear and IM/110 (a 10% diffusion). An
enhanced brightness version incorporating high efficiency
optical films provides and increased luminance of up to
33%.
This module is composed of a color TFT-LCD panel, driver
ICs, control circuit, power supply circuit and a backlight
unit. Graphics and text can be displayed on a 640 X 3
X 480 dot panel with 262,144 color by supplying 18-bit
data signal (6bit/color), four timing signals, +3.3V/+5V
DC supply voltage for TFT-LCD panel driving and supply
voltage for backlight.
The TFT-LCD panel used for this module is a low-reflection
and higher-color-saturation type. Therefore, this module
is also suitable for multimedia use. Optimum viewing
direction is 12 o'clock.
This module is the type of wide viewing angle and high
brightness. Backlight-driving DC/AC inverter is not built
in this module.
White assumes no responsibility for any damage resulting
from the use of the device which does not comply with
the instructions and the precautions specified in these
specification sheets. White does assume the responsibility
for the warranty of the enhanced product.
MECHANICAL SPECIFICATIONS
Parameter
Display size
Active area
Pixel format
Pixel pitch
Pixel configuration
Display mode
Unit outline dimensions (1)
Mass
Surface treatment
Note:
1. Excluding backlight cables and mounting tabs.
Specifications
21 (8.4") Diagonal
170.9 (H) x 129.6 (V)
640 (H) x 480 (V)
(1 pixel=R+G+B dots)
0.267 (H) x 0.270 (V)
R,G,B vertical stripe
Normally white
216.0 (W) x 152.4 (H) x 12.0(D)
410 ± 20
IM/Clear (glossy) or IM/110 and hardcoat 3H
Units
cm
mm
pixel
-
mm
-
-
mm
g
-
Note: This measurement is typical, and see Fig. 3 for details.
White Electronic Designs Corp. reserves the right to change products or specifications without notice.
Original specifications created by Sharp.
September, 2004
Rev. 1
1
Display Systems Division • Hillsboro, OR • (503) 690-2460 • www.wedc.com