JF Datasheet, PDF (5/6 Pages) Wall Industries,Inc. – 15W Open Frame DC/DC Power Converters

MECHANICAL DRAWING
DIP TYPE (Standard)
Rev. C
JF Series
Single Outputs
2:1 Input Voltage Range
15W DC/DC Power Converters
1. Unit: inches (mm)
2. Tolerance: X.XX±0.02 (X.X±0.5)
X.XXX±0.01 (X.XX±0.25)
3. Pin pitch tolerance: ±0.01 (±0.25)
4. Pin dimension tolerance: ±0.004 (±0.1)
SMT TYPE (Suffix “S”)
ETERNAL OUTPUT TRIMMING
Output can be externally trimmed by using
the method shown below.
TRIM UP
6
R_U
5
TRIM DOWN
5
R_D
4
PIN CONNECTIONS
PIN
JF SERIES
1
+INPUT
2
-INPUT
3
CTRL
4
+OUTPUT
5
TRIM
6
-OUTPUT
PRODUCT OPTIONS
Option
Positive Remote ON/OFF with DIP (standard)
Positive remote ON/OFF with SMT
Negative Remote ON/OFF with DIP
Negative Remote ON/OFF with SMT
DIP type without ON/OFF pin
SMT type without ON/OFF pin
DIP type without ON/OFF & TRIM pin
SMT type without ON/OFF & TRIM pin
DIP type, negative remote ON/OFF, without TRIM pin
SMT type, negative remote ON/OFF, without TRIM pin
DIP type, positive remote ON/OFF, without TRIM pin
SMT type, positive remote ON/OFF, without TRIM pin
11/11/2011
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax [phone]
Suffix
No Suffix
S
R
SR
D
SD
G
SG
F
SF
J
SJ
Page 5 of 6