RA2415UW8 Datasheet, PDF (3/11 Pages) Wall Industries,Inc. – 8 W DC-DC Converter

WALL INDUSTRIES, INC. _{Rev. D}
TECHNICAL DATASHEET
RA2415UW8
Figure 1: Mechanical Dimensions
NAVSEA NUMBER
LABEL
DENOTES PIN-1
DC/DC
CONVERTER
8246297-2
XXXX XXXX EXETER, NH 03833 USA
ESD
DATE CODE
BAR CODE, CONTAINS:
SERIAL NO, DATE CODE &
BOM REVISION LEVEL
SERIAL NUMBER
.60 [15.2]
123
.80 [20.3]
9 11
PIN Ø.02 [0.5]
23 22
16 14
NOTES:
1.25 [31.8]
1. Pin to Pin Tolerance: ± 0.01 (±0.3)
2. Pin Diameter Tolerance: ±0.005 (±0.13)
3. Unless otherwise specified all dimensions are in inches [XX] are in millimeters.
4. Applied Tolerances: Angles ±1°, .XX = ±0.02 [0.5] .XXX = ± 0.010 [0.25]
5. Do not scale drawing. Interpret dimension and tolerance per ASME Y14.5M – 1994
6. Third Angle Projection
7. Pin Material: Brass alloy “360, ½ Hard” per ASTM B16-85; chemical composition: 61.5% Cu, 35.4% Zn, 3.1% Pb
8. Pin Finish: 10u Gold over Nickel. Meets the solderability requirements of MIL-STD-202, Method 208.
9. PCB Cleaning: Devices shall be capable of exposure to the following PCB assembly cleaning processes: Aquanox XJN+ an aqueous cleaner
chemistry made by Kyzen Corp. This solution operates at a concentration of 25% XJN and 75% deionized water sprayed onto the device at 25-40
PSI. This cleaning process includes the following steps:
a. Pre-wash and wash at 150°F. Dwell time 3-4 minutes.
b. Isolation water rinse at 140°F
c. Deionized water rinse at 140°F
d. Final deionized water rinse
e. Blower dry
f. 1 hour CCA bake at 125 Deg F prior to CCA conformal coat.
10. Unit is not hermetically sealed
11. Pin Table:
Pin # Description
Pin Ø
1
Enable
0.020 (0.51)
2
-V_in
3
-V_in
0.020 (0.51)
0.020 (0.51)
9
NC
0.020 (0.51)
11 NC
0.020 (0.51)
14
+V_out
16
-V_out
22
+V_in
23
+V_in
0.020 (0.51)
0.020 (0.51)
0.020 (0.51)
0.020 (0.51)
(888) 597-WALL
www.wallindustries.com
Page 3 of 11