PSM200 Datasheet, PDF (1/3 Pages) Powersem GmbH – Silicon Power Diode

Rev. D
PSM200 Series
Single Output
200 Watt, U-Chassis
AC/DC Medical Power Supply
FEATURES
● Active PFC
● Single Output
● High Reliability
● RoHS Compliant
● Medical Approved
● 100% Hi-pot Tested
● 100% Burn-in Tested
● 90~264VAC Input Range
● Safety Approvals, EMC Compliance
● Short Circuit, Over Load, and Over Voltage Protected
DESCRIPTION
The PSM200 series of AC/DC medical power supplies provides 200 Watts of continuous output power in a U-chassis design.
All models have a single output, 90~264VAC full range input, and active PFC. These supplies are designed to comply with
UL60601-1, TUV EN60601-1, and CB IEC60601-1 requirements. All models are protected against short circuit, over load,
and over voltage conditions. This series is 100% hi-pot and burn-in tested.
SPECIFICATIONS: PSM200 Series
All specifications are based on 25°C, Nominal Input Voltage, and Maximum Output Current unless otherwise noted.
We reserve the right to change specifications based on technological advances.
INPUT SPECIFICATIONS
Input Voltage Range
Input Frequency
Input Current (rms)
Leakage Current
OUTPUT SPECIFICATIONS
Output Current
Output Voltage
Voltage Regulation
Output Power
Ripple & Noise (20MHz BW) (See Note 1)
Hold Up Time
90 ~ 264VAC (Full Range)
47 ~ 63Hz
3A at 90VAC max. 1.5A at 264VAC max.
< 300µA at 264VAC
See Table
See Table
±5%
200W max.
See Table
> 16ms typical at 115VAC and full load
PROTECTION
Short Circuit Protection
Over Voltage Protection
Over Load Protection
GENERAL SPECIFICATIONS
Efficiency
No Load Power Consumption
Power Factor
Auto recover
Latch, AC recycle
Auto recover
> 87% at 115VAC and full load
< 500mW
> 0.9 at 115VAC/230VAC and full load
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature
Storage Temperature
Humidity
MTBF
PHYSICAL SPECIFICATIONS
Dimensions (L x W x H)
Weight
SAFETY & EMI
Safety Standards
EMC Standards
0°C ~ +40°C convection cooling
-10°C to +85°C
20% ~ 90%
>140,000 hours at full load and 25°C ambient temperature
6.94 x 3.74 x 1.97 inches
176 x 95 x 50 mm
1.3 lbs (580g)
UL/c-UL UL60601-1, CSA C22.2-No. 60601-1, TUV EN60601-1, CB IEC60601-1
EN60601-1-2, FCC Part 18 Class B, EN55011 Class B, CE
08/01/2011
Wall Industries, Inc. 5 Watson Brook Road Exeter, NH 03833
603-778-2300 www.wallindustries.com Fax [phone]
Page 1 of 3