STDA130-SERIES Datasheet, PDF (2/2 Pages) Vitec Power – 130W Desktop (or Mounting Tab) Power Supply for I.T. Equipment

Electrical Characteristics
Parameter
Test Conditions
Input Voltage
Operating Voltage
Input Frequency
Power Factor Correction
Output Power Range
Io=Full load, Vin=230VAC
Vin=90 to 260VAC
Input Current (Low Line)
Io=Full load, Vin=115VAC
Input Current (High Line)
Low Line Inrush Current
Io=Full load, Vin=230VAC
Io=Full load, 25°C ,Cool start, Vin=115VAC
High Line Inrush Current
Io=Full load, 25°C, Cool start, Vin=230VAC
Efficiency
Line Regulation
Io=Full Load, Vin=230VAC
Io=Full Load
Load Regulation
Vin=230VAC
Over Voltage Protection
Over Current Protection
Transient Response
Io=Full Load to Half Load, Vin=100VAC
Hold-Up Time
Start Up Time
Io=Full Load, Vin=110VAC
Io=Full Load, Vin=100VAC
* Ripple & Noise (Peak to Peak)
Full Load, Vin=90VAC
Safety Ground Leakage Current
Temperature Coefficient
Io=Full Load, Vin=240VAC
All output
* The Ripple & Noise is under 3.3VDC at 2% max
Conditions
Parameter
Test Conditions
Operating Temperature
Storage Temperature
Relative Humidity
Operation temperature at 25°C, calculated per MIL-HDBK-217F
Derate linearly from 100% load at 25°C to 50% load at 70°C
Min.
90
47
0.95
0
112
110
50
0.3
-0.04
Min.
0
-40
5
0.1M
Approvals and Compliance
Parameter
Test Conditions
Dielectric Withstanding Voltage for Primary to secondary
Primary to secondary
Dielectric Withstanding Voltage for Primary to Ground
Primary to ground
Isolation Resistance
Test Voltage = 500VDC
EMI requirements for CISPR-22
Vin=220VAC
EMI requirements for FCC PART-15
Vin=110VAC
Mechanical and PIN out
Typ.
Max.
Unit
260
VAC
63
Hz
1.00
130
W
1.7
3.2
A
0.7
1.7
A
15
30
A
30
60
A
80
85
%
0.5
1
%
3
10
%
132
%
150
%
4
mS
mS
1
2
S
0.5
1
%
0.5
0.75
mA
0.04
%/°C
Typ.
Max.
Unit
25
70
°C
85
°C
95
%
Hrs
Min.
4242
2121
50
B
B
Unit
VDC
VDC
MΩ
CLASS
CLASS
Note:
1. Dimensions are shown in mm & inch
2. Weight: 750~916g approx
(Exclude the input cord)
3. Optional output connector.