ILPA50VW-SERIES Datasheet, PDF (1/2 Pages) Vitec Power – 50W Water-Proof Constant Voltage LED Driver

ILPA50VW SERIES
2 Year Warranty
50W Water-Proof Constant Voltage LED Driver
– Wide Input Voltage 90 to 264VAC, 47 to 63Hz
– Constant Output Voltage Available for 12VDC and 24VDC
– Over Voltage, Short Circuit, and Over Temperature Protection
– High Efficiency (up to 86%)
– Active Power Factor Correction (PFC) (87% typical)
– IP67 Waterproof Rating, Metal Housing
– Comply with UL8750 & EN61347 Safety Regulation (Pending)
Approvals:
Single Output
Part Number
Output Voltage
Max.
Output Current
ILPA50VW-050S012SS
12 VDC
3.00 A
ILPA50VW-050S024SS
24 VDC
2.10 A
Item -050S012SS, -050S024SS use Class 2 output (USR & CNR).
Efficiency
(220VAC, Full Load)
84%
86%
Over Voltage Protection
Min / Typ / Max
14V / 16V / 18V
29V / 33V / 36V
Max.
Output Power
36W
50W
Parameter
Input Voltage
Input Frequency
Output Power Range
Input Current (Low Line)
Input Current (High Line)
High Line Inrush Current
Power Factor Correction
Power Factor Correction
Efficiency
No-Load Power Consumption
Line Regulation
Load Regulation
Over Voltage Protection
Over Current Protection
Over Temperature Protection
Short Circuit Protection
Output Overshoot / Undershoot
Start Up Time
Ripple & Noise (Peak to Peak)
Electrical Characteristics
Test Conditions
Min.
Typ.
Max.
Unit
Operating Voltage
90
264
VAC
47
63
Hz
Vin=90 to 264VAC
0
50
W
Io=Full load, Vin=115VAC
0.7
A
Io=Full load, Vin=230VAC
0.35
A
Io=Full load, 25°C, Cool start, Vin=230VAC
65
A
Vin=110VAC
86
87
%
Vin=220VAC
84
85
%
Io=Full Load, Vin=230VAC
86
%
No Load, VIn=230VAC
1
W
Io=Full Load
1
%
Vin=230VAC
3
%
Latch mode. The power unit shall return to normal operation only after the power is turn-on again.
(Please refer to output table.)
120
130
170
% Io
110
°C
No damage shall occur when any output operating in a short circuit condition. The power supply shall be
self-recovery when the fault condition is removed.
When power on or off
10
%
Io=Full Load, Vin=100VAC
3
S
Measured by 20 MHz bandwidth oscilloscope and the
output paralleled a 0.1 uF ceramic capacitor and a 10
2
% Vo
uF electrolytic capacitor.
Conditions
Parameter
Test Conditions
Operating Temperature
Humidity: 10% RH to 100% RH
Storage Temperature
Humidity: 5% RH to 100% RH
Operation temperature at 25°C, calculated per MIL-HDBK-217F
Life Time at 25°C ambient temperature
No output power derating from -35°C to 70°C
Min.
Typ.
-35
-40
0.3M
0.08M
Max.
60
85
Unit
°C
°C
Hours
Hours