MT3A Datasheet, PDF (1/2 Pages) Volgen Kaga Electronics Inc. – All specifications are typical at nominal input, full load and 25ºC otherwise noted

MT3A- series
T E C H N I C A L S P E C I F I C A T I O N All specifications are typical at nominal input, full load and 25ºC otherwise noted
OUTPUT SPECIFICATIONS
INPUT SPECIFICATIONS
Output power
Voltage accuracy
Full load and nominal Vin
3 Watts, max.
± 1% ^{Input voltage range}
Minimum load (Note 5)
Line regulation
Load regulation
LL to HL at Full Load
Single
Min Load to Full Load
Dual
See table
Input filter
± 0.2%
3.3Vout
Others
± 0.3% Input surge voltage
± 0.2% 100mS max
± 2%
5V nominal input
12V nominal input
24V nominal input
48V nominal input
5V input
12V input
24V input
48V input
4.5 – 6VDC
9 – 18VDC
18 – 36VDC
36 – 75VDC
Pi type
15VDC
36VDC
50VDC
100VDC
Cross regulation (Dual) Asymmetrical load 25% / 100% FL
± 5% _{Input reflected ripple current Nominal Vin and full load}
120mAp-p
Ripple and noise
20MHz bandwidth
Temperature coefficient
See table _{Start up time}
Nominal Vin and
Power up
constant resistive load
±0.02% / ºC, max.
ENVIRONMENTAL SPECIFICATIONS
30mS, typ.
Transient response recovery time 25% load step change
500µS
Operating ambient temperature
Over load protection % of FL at nominal input
180%, typ.
Storage temperature range
Short circuit protection
Continuous, automatics recovery
Maximum case temperature
GENERAL SPECIFICATIONS
Thermal shock
-25ºC ~ +85ºC (with derating)
-40ºC ~ +125ºC
100ºC
MIL-STD-810F
Efficiency
Isolation voltage
Input to Output
Input (Output)to case
See table _Vibration
500VDC ,min
500VDC ,min Relative humidity
MIL-STD-810F
5% to 95% RH
Isolation resistance
10⁹ohms, min. _{EMC CHARACTERISTICS}
Isolation capacitance
300pF, max. _EMI
EN55022
Class A
Switching frequency
100KHz, min.
Design meet safety standard
IEC60950-1,UL60950-1,EN60950-1
Case material
Nickel-coated copper
Base material
Non-conductive black plastic
Potting material
MTBF (Note 1)
BELLCORE TR-NWT-000332
MIL-HDBK-217F
Epoxy (UL94-V0)
3.706 x 10⁶ hrs
3.018 x 10⁶ hrs
Note
1. BELLCORE TR-NWT-000332. Case 1: 50% Stress, Temperature at 40ºC.
MIL-HDBK-217F Notice2 @Ta=25 ºC, Full load(Ground, Benign, controlled environment).
2. Maximum value at nominal input voltage and full load.
3. Typical value at nominal input voltage and full load.
4. Test by minimum Vin and constant resistive load.
5. The output requires a minimum loading on the output to maintain specified regulation. Operation under no-load condition will not
damage these devices, however they may not meet all listed specification.