|
BFC233860332 Datasheet, PDF (8/15 Pages) Vishay Siliconix – Interference Suppression Film Capacitor - Class Y2 Radial MKP 300 VAC - Line to Ground Application | |||
|
◁ |
www.vishay.com
MKP338 6 Y2
Vishay BCcomponents
MOUNTING
Normal Use
The capacitors are designed for mounting on printed-circuit boards. The capacitors packed in bandoliers are designed for
mounting in printed circuit boards by means of automatic insertion machines.ï
For detailed tape specifications refer to packaging information: www.vishay.com/doc?28139
Specific Method of Mounting to Withstand Vibration and Shock
In order to withstand vibration and shock tests, it must be ensured that the stand-off pips are in good contact with the
printed-circuit board:
⢠For pitches ï£ 15 mm capacitors shall be mechanically fixed by the leads
⢠For larger pitches the capacitors shall be mounted in the same way and the body clamped
Space Requirements on Printed-Circuit Board
The maximum space for length (Imax.), width (wmax.), and height (hmax.) of film capacitors to take in account on the printed-circuit
board is shown in the drawings:
⢠For products with pitch ï£ 15 mm, ïw = ïl = 0.3 mm; ïh = 0.1 mm
⢠For products with 15 mm < pitch, ï£ 27.5 mm, ïw = ïl = 0.5 mm; ïh = 0.1 mm
Eccentricity defined as in drawing. The maximum eccentricity is smaller than or equal to the lead diameter of the product
concerned.
Eccentricity
wmax. = W + Î
Imax. = I + Î
CBA116
hmax. = h + Î
Seating plane
SOLDERING CONDITIONS
For general soldering conditions and wave soldering profile, we refer to the application note: ï
âSoldering Guidelines for Film Capacitorsâ: www.vishay.com/doc?28171
Storage Temperature
Tstg = - 25 °C to + 35 °C with RH maximum 75 % without condensation
Ratings and Characteristics Reference Conditions
Unless otherwise specified, all electrical values apply to an ambient temperature of 23 °C ± 1 °C, an atmospheric pressure of
86 kPa to 106 kPa and a relative humidity of 50 % ± 2 %.
For reference testing, a conditioning period shall be applied over 96 h ± 4 h by heating the products in a circulating air oven at
the rated temperature and a relative humidity not exceeding 20 %.
Revision: 10-Dec-13
8
Document Number: 28114
For technical questions, contact: rfi@vishay.com
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
|
▷ |