MKP1840310104M Datasheet, PDF (5/13 Pages) Vishay Siliconix – AC and Pulse Metallized Polypropylene Film Capacitors MKP Radial Potted Type

MKP 1840 M
AC and Pulse Metallized Polypropylene Film Capacitors _{Vishay Roederstein}
MKP Radial Potted Type
MOUNTING
Normal Use
The capacitors are designed for mounting on printed-circuit boards. The capacitors packed in bandoliers are designed for
mounting in printed-circuit boards by means of automatic insertion machines.
For detailed tape specifications refer to “Packaging Information” www.vishay.com/doc?28139 or end of catalog
Specific Method of Mounting to Withstand Vibration and Shock
In order to withstand vibration and shock tests, it must be ensure that the stand-off pips are in good contact with the
printed-circuit board:
• For pitches ≤ 15 mm capacitors shall be mechanically fixed by the leads
• For larger pitches the capacitors shall be mounted in the same way and the body clamped
Space Requirements on Printed-Circuit Board
The maximum length and width of film capacitors is shown in the drawing:
• Eccentricity as in drawing. The maximum eccentricity is smaller than or equal to the lead diameter of the product concerned
• Product height with seating plane as given by “IEC 60717” as reference: h_max. ≤ h + 0.4 mm or h_max. ≤ h’ + 0.4 mm
Eccentricity
b_max. = b + 0.3 mm
I_max. = I + 0.3 mm
Storage Temperature
• Storage temperature: T_stg = - 25 °C to + 40 °C with RH maximum 80 % without condensation
Ratings and Characteristics Reference Conditions
Unless otherwise specified, all electrical values apply to an ambient free temperature of 23 °C ± 1 °C, an atmospheric pressure
of 86 kPa to 106 kPa and a relative humidity of 50 % ± 2 %.
For reference testing, a conditioning period shall be applied over 96 h ± 4 h by heating the products in a circulating air oven at
the rated temperature and a relative humidity not exceeding 20 %.
Document Number: 26018
Revision: 01-Jul-10
For technical questions, contact: [e-mail]
www.vishay.com
151