BFC238370682 Datasheet, PDF (23/26 Pages) Vishay Siliconix – AC and Pulse Double Metallized Polypropylene Film Capacitors

Not Recommended for New Design, Use New MMKP383
MMKP 383
AC and Pulse Double Metallized Polypropylene _{Vishay BCcomponents}
Film Capacitors MMKP Radial Potted Type
INSPECTION REQUIREMENTS
General Notes:
Sub-clause numbers of tests and performance requirements refer to the “Sectional Specification, Publication IEC 60384-17 and
Specific Reference Data”.
Group C Inspection Requirements
SUB-CLAUSE NUMBER AND TEST
SUB-GROUP C1A PART OF SAMPLE
OF SUB-GROUP C1
4.1
Dimensions (detail)
4.3.1 Initial measurements
4.3
Robustness of terminations
4.4
Resistance to soldering heat
4.14 Component solvent resistance
4.4.2 Final measurements
SUB-GROUP C1B OTHER PART OF
SAMPLE OF SUB-GROUP C1
4.6.1 Initial measurements
4.15 Solvent resistance of the marking
4.6
Rapid change of temperature
4.7
Vibration
CONDITIONS
Capacitance
Tangent of loss angle:
For C  1 µF at 100 kHz or
for C > 1 µF at 10 kHz
Tensile: Load 10 N; 10 s
Bending: Load 5 N; 4 x 90°
Method: 1A
Solder bath: 280 °C ± 5 °C
Duration: 10 s
Isopropylalcohol at room temperature
Method: 2
Immersion time: 5 min ± 0.5 min
Recovery time: Min. 1 h, max. 2 h
Visual examination
Capacitance
Tangent of loss angle
Capacitance
Tangent of loss angle:
For C  1 µF at 100 kHz or
for C > 1 µF at 10 kHz
Isopropylalcohol at room temperature
Method: 1
Rubbing material: cotton wool
Immersion time: 5.0 min ± 0.5 min
A = - 55 °C
B = + 105 °C
5 cycles
Duration t = 30 min
Visual examination
Mounting: see section “Mounting” for more
information
Procedure B4
Frequency range: 10 Hz to 55 Hz
Amplitude: 0.75 mm or
Acceleration 98 m/s²
(whichever is less severe)
Total duration 6 h
PERFORMANCE REQUIREMENTS
As specified in chapters “General Data” of
this specification
No visible damage
No visible damage
Legible marking
C/C|  1 % of the value measured initially
Increase of tan 
 0.0005 for: C  100 nF or
 0.001 for: 100 nF < C  470 nF or
 0.0015 for: C  470 nF
Compared to values measured in 4.3.1
No visible damage
Legible marking
No visible damage
Document Number: 28124
For technical questions, contact: [e-mail]
www.vishay.com
Revision: 19-Mar-13
209
This document is subject to change without notice.
THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000