TCLT1100 Datasheet, PDF (2/9 Pages) Vishay Siliconix – Optocoupler, Phototransistor Output, SOP-6L5, Half Pitch, Long Mini-Flat Package

TCLT11..Series
Vishay Semiconductors ^{Optocoupler, Phototransistor Output,}
SOP-6L5, Half Pitch, Long Mini-Flat
Package
ABSOLUTE MAXIMUM RATINGS ⁽¹⁾
PARAMETER
TEST CONDITION
SYMBOL
VALUE
UNIT
INPUT
Reverse voltage
Forward current
Forward surge current
Power dissipation
Junction temperature
OUTPUT
V_R
6
V
I_F
60
mA
t_P ≤ 10 µs
I_FSM
1.5
A
P_diss
100
mW
T_j
125
°C
Collector emitter voltage
V_CEO
70
V
Emitter collector voltage
V_ECO
7
V
Collector current
I_C
50
mA
Collector peak current
t_P/T = 0.5, t_P ≤ 10 ms
I_CM
100
mA
Power dissipation
P_diss
150
mW
Junction temperature
T_j
125
°C
COUPLER
Isolation test voltage (RMS)
Total power dissipation
Operating ambient temperature range
Storage temperature range
Soldering temperature ⁽²⁾
V_ISO
P_tot
T_amb
T_stg
T_sld
5000
250
- 40 to + 100
- 40 to + 100
260
V_RMS
mW
°C
°C
°C
Notes
(1) _{Tamb = 25 °C, unless otherwise specified.}
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. Functional operation of the device is not
implied at these or any other conditions in excess of those given in the operational sections of this document. Exposure to absolute maximum
ratings for extended periods of the time can adversely affect reliability.
(2) _{Refer to reflow profile for soldering conditions for surface mounted devices.}
ELECTRICAL CHARACTERISTICS
PARAMETER
TEST CONDITION
SYMBOL
MIN.
TYP.
MAX.
UNIT
INPUT
Forward voltage
Junction capacitance
OUTPUT
I_F = ± 50 mA
V_F
V_R = 0 V, f = 1 MHz
C_j
1.25
1.6
V
50
pF
Collector emitter voltage
I_C = 1 mA
V_CEO
70
Emitter collector voltage
I_E = 100 µA
V_ECO
7
Collector emitter cut-off current
V_CE = 20 V, I_F = 0 A, E = 0
I_CEO
COUPLER
V
V
10
100
nA
Collector emitter saturation voltage
Cut-off frequency
Coupling capacitance
I_F = 10 mA, I_C = 1 mA
V_CE = 5 V, I_F = 10 mA,
R_L = 100 Ω
f = 1 MHz
V_CEsat
f_c
C_k
0.3
V
110
kHz
0.3
pF
Note
T_amb = 25 °C, unless otherwise specified.
Minimum and maximum values are testing requirements. Typical values are characteristics of the device and are the result of engineering
evaluation. Typical values are for information only and are not part of the testing requirements.
www.vishay.com
2
For technical questions, contact: [e-mail]
Document Number: 83514
Rev. 2.1, 09-Jan-08