DG2707 Datasheet, PDF (2/8 Pages) Vishay Siliconix – High Speed, Low Voltage, 3 Ω, Differential 4:1 CMOS Analog Multiplexer/Switch

DG2707
Vishay Siliconix
TRUTH TABLE DG2707 MULTIPLEXER, MINIQFN-16L
Enable Input
Select Input
On Switches (Pin)
EN (Pin 13)
IN2 (Pin 10)
IN1 (Pin 3)
Description (Pin)
0
0
0
S5 (Pin 12)
0
0
1
S6 (Pin 14)
0
1
0
S7 (Pin 16)
0
1
1
S8 (Pin 1)
0
0
0
S1 (Pin 4)
0
0
1
S2 (Pin 6)
0
1
0
S3 (Pin 8)
0
1
1
S4 (Pin 9)
1
X
X
All Switches are off
Pin 5 N/C
Common (Pin)
D2 (Pin 15)
D1 (Pin 7)
ABSOLUTE MAXIMUM RATINGS T_A = 25 °C, unless otherwise noted
Parameter
Limit
Unit
Reference to GND
V+
EN, IN, D_X, S_Xa
Current (Any terminal except S_X or D_X)
Continuous Current (S_X or D_X)
Peak Current (Pulsed at 1 ms, 10 % Duty Cycle)
- 0.3 to 5.0
V
- 0.3 to (V+ + 0.3)
30
± 300
mA
± 500
Storage Temperature (D Suffix)
- 65 to 150
°C
Thermal Resistance (Package)^b
Power Dissipation (Packages)^b
miniQFN-16
miniQFN-16^{c, d}
152
°C/W
525
mW
Notes:
a. Signals on S_X or D_X, or IN_X or EN exceeding V+ will be clamped by internal diodes. Limit forward diode current to maximum current ratings.
b. All leads welded or soldered to PC Board.
c. Derate 6.6 mW/°C above 70 °C
d. Manual soldering with iron is not recommended for leadless components. The miniQFN-16 is a leadless package. The end of the lead terminal
is exposed copper (not plated) as a result of the singulation process in manufacturing. A solder fillet at the exposed copper lip cannot be
guaranteed and is not required to ensure adequate bottom side solder interconnection.
www.vishay.com
2
Document Number: 68397
S-80988-Rev. A, 05-May-08