140CRH_13 Datasheet, PDF (12/13 Pages) Vishay Siliconix – Aluminum Capacitors SMD (Chip), High Temperature

www.vishay.com
140 CRH
Vishay BCcomponents
Table 10
TEST PROCEDURES AND REQUIREMENTS
TEST
NAME OF TEST
REFERENCE
PROCEDURE
(quick reference)
REQUIREMENTS
Mounting
Endurance
Useful life
IEC 60384-18,
subclause 4.3
IEC 60384-18/
CECC 32300,
subclause 4.15
CECC 30301,
subclause 1.8.1
Shall be performed prior to tests mentioned below;
reflow soldering;
for maximum temperature load refer to chapter “Mounting”
T_amb = 125 °C; U_R applied;
for test duration see Table 8
T_amb = 125 °C; U_R and I_R applied;
for test duration see Table 8
C/C: ± 5 %
tan   spec. limit
I_L2  spec. limit
U_R = 6.3 V; C/C: ± 25 %
U_R  10 V; C/C: ± 20 %
tan   2 x spec. limit
I_L2  spec. limit
C/C: ± 30 %
tan   3 x spec. limit
I_L2  spec. limit
no short or open circuit
total failure percentage: 1 %
Shelf life
(storage at high
temperature)
IEC 60384-18/
CECC 32300,
subclause 4.17
T_amb = 125 °C; no voltage applied;
1000 h
after test: U_R to be applied for 30 min,
24 h to 48 h before measurement
For requirements
see “Endurance test” above
Reverse voltage
IEC 60384-18/
CECC 32300,
subclause 4.16
T_amb = 125 °C:
125 h at U = - 0.5 V,
followed by 125 h at U_R
C/C: ± 15 %
tan   1.5 x spec. limit
I_L2  spec. limit
Revision: 26-Apr-13
12
Document Number: 28396
For technical questions, contact: [e-mail]
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000