SMM0207_11 Datasheet, PDF (1/6 Pages) Vishay Siliconix – Thin Film MELF Resistors

SMM0207
Vishay Draloric
Thin Film MELF Resistors
FEATURES
 MELF resistor with high power rating
 AEC-Q200 qualified
 Advanced thin film technology
 Pure tin termination on nickel barrier, plated on
press fit steel caps
 Compliant to RoHS Directive 2002/95/EC
STANDARD ELECTRICAL SPECIFICATIONS
MODEL
POWER RATING ⁽¹⁾
P₇₀
W
LIMITING ELEMENT
VOLTAGE
DC or AC_RMS
V
TEMPERATURE
COEFFICIENT
ppm/K
TOLERANCE
%
RESISTANCE
RANGE

E-SERIES
SMM0207
1.0
350
± 50
± 0.5
1R0 to 2M21
24; 96
SMM0207
1.0
350
± 50
±1
1R0 to 10M
24; 96
SMM0207
1.0
350
± 100
±5
R16 to R91
24
Zero-Ohm-Resistor: OMM0207
R_max. = 10 m I_max. = 5 A
Note
(1) _{Permissible dissipation depends on the maximum temperature at the solder joint, the component placement density and the substrate}
material.
TECHNICAL SPECIFICATIONS
PARAMETER
UNIT
SMM0207
Power rating P₇₀
W
1
Limiting element voltage, DC or AC_RMS
V
350
Insulation voltage (1 min), DC or AC_PEAK
V
Insulation resistance

500
 10¹⁰
Category temperature range
C
- 55 to + 155
Failure rate: FIT_observed
 0.1 x 10^-9/h
Notes
• The power dissipation on the resistor generates a temperature rise against the local ambient, depending on the heat flow support of the
printed-circuit board (thermal resistance). The rated dissipation applies only if the permitted film temperature of 155 °C is not exceeded.
• The specification of this product is based on a test board, providing a thermal resistance of approximately 85 K/W.
• These resistors do not feature a limited lifetime when operated within the permissible limits. However, resistance value drift increasing over
operating time may result in exceeding a limit acceptable to the specific application, thereby establishing a functional lifetime.
** Please see document “Vishay Material Category Policy”: www.vishay.com/doc?99902
www.vishay.com
For technical questions, contact: [e-mail]
Document Number: 20005
36
Revision: 28-Jun-11
This document is subject to change without notice.
THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000