SMM0102_15 Datasheet, PDF (1/5 Pages) Vishay Siliconix – Thin Film Micro-MELF Resistors

SMM0102
Vishay Draloric
Thin Film Micro-MELF Resistors
FEATURES
 Advanced thin film technology
 Low TCR and tight tolerances
 Excellent stability
 Pure tin termination on nickel barrier, plated on
press fit steel caps
 Compliant to RoHS Directive 2002/95/EC
STANDARD ELECTRICAL SPECIFICATIONS
MODEL
POWER RATING ⁽¹⁾
P₇₀
W
LIMITING ELEMENT
VOLTAGE DC or AC_RMS
V
TEMPERATURE
COEFFICIENT
ppm/K
TOLERANCE
%
RESISTANCE
RANGE

SMM0102
0.2
150
± 15
± 0.1
100R to 100K
E-SERIES
24; 96
SMM0102
0.2
150
± 25
± 0.1
100R to 100K
24; 96
SMM0102
0.2
150
± 50
± 1.0
10R to 2M21
24; 96
Zero-Ohm-Resistor: OMM0102
R_max. = 10 m
I_max. = 2 A
Note
(1) _{Permissible dissipation depends on the maximum temperature at the solder joint, the component placement density, the substrate material}
and PCB layout.
TECHNICAL SPECIFICATIONS
PARAMETER
UNIT
SMM0102
Power rating P₇₀
W
Limiting element voltage, DC or AC_RMS
V
Insulation voltage (1 min), DC or AC_PEAK
V
Thermal resistance
K/W
0.2
150
200
 250
Insulation resistance

 10⁹
Category temperature range
°C
- 55 to + 125
Failure rate: FIT_observed
 0.1 x 10^-9/h
Notes
• The power dissipation on the resistor generates a temperature rise against the local ambient, depending on the heat flow support of the
printed-circuit board (thermal resistance). The rated dissipation applies only if the permitted film temperature of 125 °C is not exceeded.
• The specification of this product is based on a test board according to EN 140400, providing a thermal resistance of approximately 275 K/W.
• These resistors do not feature a limited lifetime when operated within the permissible limits. However, resistance value drift increasing over
operating time may result in exceeding a limit acceptable to the specific application, thereby establishing a functional lifetime.
** Please see document “Vishay Material Category Policy”: www.vishay.com/doc?99902
www.vishay.com
26
For technical questions, contact: [e-mail]
Document Number: 20003
Revision: 16-Aug-11
This document is subject to change without notice.
THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000