M35 Datasheet, PDF (1/5 Pages) Vishay Siliconix – Wet Tantalum Capacitors Surface Mount, Molded Case

M35
Vishay
Wet Tantalum Capacitors Surface Mount, Molded Case
FEATURES
PERFORMANCE CHARACTERISTICS
• Molded surface mountable design
• Terminations: standard tin/lead (SnPb),
100 % tin (RoHS compliant) available
• Industry standard ratings
Pb-free
Available
RoHS*
COMPLIANT
• Model M35 wet tantalum electrolytic chip capacitors
incorporate the advantages of all the varieties of
electrolytic capacitors and eliminate most of the
disadvantages. These units have a 3 V reverse voltage
capability at + 85 °C and a higher ripple current capability
than any other electrolytic type with similar combinations of
capacitance and case size.
• Compliant to RoHS directive 2002/95/EC
Operating Temperature: - 55 °C to + 85 °C
(To + 125 °C with voltage derating)
Capacitance Tolerance: At 120 Hz, + 25 °C. ± 20 %
standard. ± 10 %, ± 5 % available as special.
Life Test: Capacitors are capable of withstanding a 2000 h
life test at a temperature of + 85 °C or + 125 °C at the
applicable rated DC working voltage.
Following life test:
DC Leakage Current (DCL Max.): At + 25 °C and above:
Leakage current shall not exceed the values listed in the
Standard Ratings Tables.
1. DCL, measured at + 85 °C rated voltage, shall not be in
excess of the original requirement.
2. The equivalent series resistance shall not exceed 150 %
of the initial requirement.
3. Change in capacitance shall not exceed 10 % from the
initial measurement.
ORDERING INFORMATION
M35
C
826
M
125
B
MODEL CASE CAPACITANCE CAPACITANCE DC VOLTAGE RATING
CODE
TOLERANCE
AT + 85 °C
TERMINATION AND
PACKAGING
See
Ratings
and
Case
Codes
Table
This is
expressed in
picofarads.The
first two digits
are the
significant
figures. The
third is the
number of zeros
to follow.
K = ± 10 %
M = ± 20 %
This is expressed in V.
To complete the
three-digit block, zeros
precede the voltage
rating. A decimal point
is indicated by an “R”
(6R3 = 6.3 V).
A = 100 % tin (RoHS
compliant), bulk
B = Std, tin/lead, bulk
Packaging: The use of formed plastic trays for packing bulk components is standard.
Z
RELIABILITY
LEVEL
Z = Non-ER
S
L
TEMP ESR
S = Std. S = Std.
L = Low
DIMENSIONS in millimeters
L
W
CASE CODE
M35
L (MAX.)
21.2
W
8 ± 0.3
H
7.5 ± 0.3
* Pb containing terminations are not RoHS compliant, exemptions may apply.
P (MIN.)
3.0
www.vishay.com
1
For technical questions, contact: [e-mail]
T_W
6.0 ± 0.3
P
T_H (MIN.)
1.9
Document Number: 40095
Revision: 09-Sep-09